Security Mode
I1'1'1' I '
Before you begin...
• Connect Camcorder to power source.
Use AC Adaptor for longer recordings,
• Insert cassette with record tab (page 15),
• Set POWER to CAMERA.
• Securely position and aim Camcorder.
1
Motion Security may mistakenly start
when:
• background is plain, like a white wall, or
has distinct vertical, horizontal'or slanted
stripes, like a venetian blind,
• brightness suddenly changes.
Motion Security may not start when:
• motion is very slow or fast.
• moving object is very small.
• motion occurs only in 1 corner of viewing
area.
• in poor lighting (in this case, MOTION
SECURITY flashes).
• background is plain, like a white wall, or
has distinct horizontal or vertical stripes.
1
2
3
Slide DIGITAL SELECT to EIS.
Press MENU for MENU mode.
Press UP A or F .,_ = )
A
DOWN • to select |D,s_aY o. |
""'-"_ SEU: DEMO OPP
k-!=..,:ll.-, /
SEkE_r : PUSH _IA _W
SET : PUSH DIsF_AY KE'_f
NO ; PUSH MF.,NU KEY
Press DISPLAY to select ON.
4
Press MENU for Motion Security
stand-by mode. (If cassette is not
inserted, "1;"_" will flash.)
MOTI MOTION
Recording will start about 3
seconds after motion is detected.
• Date and time are recorded if
displayed in EVF or LCD monitor
(page 21).
• Recording stops 30 seconds after
motion ceases.
Note:
• Security recording starts if Camcorder is
bumped or repositioned,
• This feature is not available during normal
recording.
• While in Motion Security stand-by, the
following functions are not available:
Record/Pause, Stand-by mode, Digital
E.I.S., Video Effects.(AutO!Digital Fade,
Digital Filter).
To cancel Security Mode, set POWER to
OFF.
45
To Next Page
Loading...
