PC Connection
A live or captured image can be transferred to your PC (Personal Computer).
• IBM PC/AT or compatible.
lntel ® Pentium _ Processor
• Microsoft ®Windows®95 or Windows®98.
• RAM: 16 MB or more
• 2 MB of available hard-disk space.
• 256 color monitor (full color recommended),
° 3.5 inch 1.44 MB floppy disk drive (for installation).
• RS-232C serial port {D-Sub 9-pin). An adaptor (D-Sub 9-pin male to a D-Sub female)
is required for a D-Sub 25-pin.
• Mouse or other pointing device.
Connect Camcorder PC jack to the seriat
port on your PC (Personal Computer)
using the supplied PC connector cable.
Refer to PC or Windows manual to identify
which COM port to be used for connection.
Before you begin...
• Turn your PC off,
• Set CamcorderPOWERto OFF,
Note:
• Be sure to turn PC off before connection
for properly image transfer.
° After Camcorder and PC are connected
by slarting up the software included,
video recording is not possibte.
1
-_-J_(D-Sub 9-pin)
PC Connector
cable
(supplied)
PC Connector
To Next Page
Loading...
