Viewfinder/L CD Monitor Indications
Tape remaining and battery charge level can be displayed.
2 1 Set POWER to CAMERA.
Press _ repeatedly to
select the following displays.
Fifth First
pres/_s __2:®:co,_ _ press
4w
(Initial screen) 11
• Tape remaining indicator operates a few
seconds after tape starts moving.
Do steps 1 and 2 above to select time/
date. date only, or t}odisplay.
Start a recording (page 23).
• Only the Date and/or Time are recorded.
No Indication, except Intelligent Titler
(pages 46-48). wilt be displayed. I" . _'_ _ "1
l l
SEt.F _ ;_
Press MENU for MENU mode. _'_ _'_
Press UP ,i, or DOWN V to select_ ._c_...,.t._
SET : PtL_N 13_'T,_LAyKE_
•Press DISPLAY to select OFF. CAMERAMODE
Press M_ENUto exit.
Press DISPLAY repeatedly to remove time/date•
Indications are restored when Camcorder is turned off,
and then on again:'
Before you begin...
• Connect Camcorder to power source,
• Set POWER to CAMERA or VCR.
VCR MODE
To Next Page
Loading...
