Playing Back Recordings
v • . ,. -, v - . Before you begin...
Connect Camcorder to a TV to view • ConnectCamcorderto powersource.
playback or recordings in progress. • Makeall TV-Camcorderconnections.
_I, TV with AUDIO/VIDEO IN Jacks.
I[IT
To Audio
Audio/Video
Cable
(Supplied)
Set POWER to:
VCR --, view playback.
CAMERA --* view picture as it is
recorded.
Turn TV ON and set to LINE
INPUT.
See TV owner's manual.
Begin playback or recording.
To Audio/Video Out
TV without AUDIO/VIDEO IN Jacks.
To Audio/ __.
If TV has no VIDEOtAUDIO IN jacks,
connect PV-RF16 RF Adaptor
(optional, page 76). Tune TV to CH 3
or 4 to match RF Adaptor CH 314
Selector. Set Adaptor's TViVCR
Selector to VCR for playback.
RF Adaptor C Turn TV ON and select channel,
T VHF Antenna
_'1] 300 ofim-75 ohm
CH 3/4 Selector J_'Jl transformer
or FConnector
/ _ UHF Antenna
!v.NCR -
Selector IF Back of TV
V.F onooc,,o0
Cable
To VHF Antenna _ ]
Terminal
To watch TV only,
a Set Camcorder POWER to OFF.
b Set RF Adaptor TV/VCR Selector to TV.
CATV System Installer
This reminder is provided to call the
CATV system instaUer'sattention to
Article 820-40 of the NEC in USA (and
to the Canadian ElectricalCode in
Canada) that provides guidelines for
proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of
thebuilding, as close to the point of
cable entry as practical,
31.
To Next Page
Loading...
