Before Use
Quick Guide
1 Attach the Battery to the AC Adaptor and
charge it.
eBefore use, fully charge the Battery.
eSince the Battery will not be charged when
the DC Cable is connected to the AC
Adaptor, disconnect it from the AC Adaptor.
eThe [CHARGE] Lamp lights up, and charging
starts.
eWhen the [CHARGE] Lamp goes off,
charging is completed.
2 Attach the charged Battery to the
Camcorder.
• Inserting a Cassette
1 Slide the [OPEN/EJECT] Lever O toward
the front and pull down to open the
Cassette Compartment Cover.
2 Insert a Cassette.
3 Close the Cassette Holder by pressing the
[PUSH] mark _.
4 Close the Cassette Compartment Cover.
• Inserting a Card
1 Slide the [OPEN] Lever O to open the Card
Slot Cover _.
O
2 While holding the Memory Card with its cut
corner on top O, insert it into the Card Slot.
3 Close the Card Slot Cover O securely.
• Recording on a Tape
1 Set the [OFF/ON] Switch _ to [ON].
eThe [POWER] Lamp _ lights up.
O O
O
2 Set the Mode Dial to Tape Recording Mode.
3 Press the Recording Start/Stop Button.
• Recording starts.
4 Press the Recording Start/Stop Button
again to pause the recording.
-10-
To Next Page
Loading...
