Editing Mode
5 Te start Audio Dubbing, press the [l l]
Button _ on the Remote Controller.
To Cancel Audio _ubbing
PreSS the [11] Button _ on the Remote
Controller.
The C;._mcordcr is in the Still Playb;._ck Mode
again.
TO Play Back the Sound Recorded by 12bit
Audio Dubbing
Set [TAPE PLAYBACK MENU] >> [PLAYBACK]
>> [12bit AUDIO] >> [ST2] or [MIXJ.
ST1 : It plays back only the original sound.
ST2: It plays back only the sound added by AudJo
Dubbing.
MIX: It plays back both the original sound and the
sound added by Audio Dubbing
simultaneously.
TO #ub Audio Wh#e Listening to a
Prerecorded Sound
When p:.wsingthe audiodubbing,sotthe
[12bit AUDIO] on the [PLAYBACK] Sub-Menu to
[ST21 and you can shook the pro-rccelded sound.
When a microphone is used for audio dubbing,
use headphones to listen to the pro-rocarded
sound while dubbing the ;.wdic. (When as{ng
headphones, sot [AV JACK] to [OUT/PHONES].)
When the Irnc input is used, you can dub audrc
while listening to the pre-roccrdcd sound from the
speaker.
• For other notes concerning this item, see -_-.
Copying on an S-VHS (or a VHS)
Cassette
(Dubbing)
After connecting the Carncorderand the VCR
as illustrated, start the following procedures,
O AV Cable
_1 S-Video Cable
• Be sure to press the [OSD] Button (-14-) on the
Remote Controller prior to copying so that no
indications are visible. Otherwise, the displayed
tape counter and function indications arc also
copied.
Camcorder:
1 Insert the recorded Cassette.
VCR:
2 Insert an unrecorded Cassette with an
erasure prevention tab.
• If various setups (such as external input, tape
speed, etc.) are required, plc_se refer to the
operating instructions of your VCR.
Camcorder:
3 Press the [1_] Button @ to start playback.
VCR:
4 Start recording.
5 Press the Pause or Step Button to step
recerding.
Camcorder:
6 Press the [11] Button _ to stop playback.
-52-
To Next Page
Loading...
