With _ PC
For Macintosh
1 Turn on Computer and start up Macintosh.
2 Insert supplied CD-ROM into the CD-ROM
drive.
3 Double click the CD-ROM icon that appears.
4 Double click [ArsSoft[.
5 Double click [Photelmpreasion] (or
[PhotoBase] or [PanoramaMaker] or
[PhotoPrinter]).
6 Double click [English] or [French].
7 Double click [Photolmpreasion Inataller] (or
[PhotoBase Installer] or
[PanoremaMaker Installer] or
[PhotoPrinter Installer]).
8 Follow the instructions on the computer
screen until the installation is complete.
• TO start software in ArcSoft Software
Suite
1 Select [Start] >> [All Programs (Programs[]
>> [ArsSoft Software Suite[ >>
[Panorama Maker 3] (or [PhoteBase 4] or
[Photolmpreasion 4] or [PhotoPrinter 4[).
For Information on AroSoft Software:
TEL: 1-510-440-9901
Web Site: www.arosaft.cam
Refer to Help information about application
operations and other Error messages.
TO disconnect USB cable safely
If USB cable is discoflnootod while computer is
on, error dialog box may appear. In such a case
click LOKJand close the dialog box. By following
thestops below you can disconno_ thecable
safely. _
1 Double click the _5 icon in task tray.
eHa_aro disconnectdialogbox appears.
2 Select [USB Mass Storage Device] and click
[Stop].
3 Verify [Matshita DVC USB Device] is
selected and click [OK].
• You c;.tn s;.doly disconncot the cable.
Note on the driver name displayed
The driver name displayed will differ depending
an your OS, operating environment and the mode
of the Camcorder.
Windows XPt20OO:
(When the Camcardor is in Tape I_ocording mode
or T;._pe PI;.wb;.tok Mode:]
[Panasanio DVC USB-SERIAL Driver far Win XX
(COM X)](The numeral designationafter%"#in"
will differ depending an the ca. The numeral aF{or
=COM" will differ depending on the operating
environment of your personal computer.]
(When the Camcorder is in PC Mode:)
[USB Mu,ss Storage Device] or
[Panasanio DV DISK Port DrivorJ
Windows Me:
(When the Camcorder is in PC Mode:
[USB Diskj
ISomo Operating Systems, such _s Windows
98SE, may nat show the icon indicating that you
may safely disconnec_ in task tray. (ca may be
set nat to show,) Make sure Camcorder's Card
Access Lamp is offand disconnect the c;.tble.
Also, with Windows Me, the icon will not be
displayed when in Tape Recording Mode or
Tape Playback Mode.
CAUTION:
If you disconnect the USB Cable while the
C;.trdAccess L;.tmpis an, it m;.ty damage tho
Card data,
-64-
To Next Page
Loading...
