Panasonic PT-AE4000U

PICTURE menu
E
NGLISH - 29
Saving a log setting as a prole
Return to the COLOR MANAGEMENT menu and
save the stored log as a prole. Make sure that the
PICTURE MODE is not switched.
Select the 1. PROFILE SAVE menu and press the
ENTER button.
The PROFILE SAVE menu is displayed. You can
save the prole as USER1, USER2 and USER3.
Indicated with
is in use, and is empty.
USER1
USER2
USER3
Press the 2. ENTER button to save the prole.
The conrmation screen is displayed. Press the
ENTER button again to save.
Name the prole.3.
Use ▲ ▼ ◄ ► to specify the location of the required
character to enter and press the ENTER button.
You can enter up to 14 characters.
OK CANCEL
ALL DELETE
PROFILE NAME INPUT
Repeat step 3 until you nish the text line.4.
Move cursor to ALL DELETE and press the ENTER
button to delete all the entered text line.
Press the DEFAULT button to delete the last entered
character or indicated with cursor in the text box.
To insert a character in the entered text line, move
the cursor to the text box to select the required place
and press ▼ then perform step 3.
Select 5. OK and press the ENTER button to set the
entered text as a name.
Press the ENTER button without entering any text to
keep the default name.
Deleting the saved proles
You can delete the proles from PROFILE
DELETE menu.
Select 1. PROFILE DELETE and press the ENTER
button.
Press ▲ ▼ to select the required prole or 2. PROFILE
ALL DELETE and press the ENTER button.
The conrmation screen will be displayed and select
OK.
Press the 3. ENTER button.
Changing the prole names
You can change the name of the proles from the
PROFILE NAME CHANGE menu.
Press ▲ ▼ to select 1. PROFILE NAME CHANGE
and press the ENTER button.
Press ▲ ▼ to select the required prole and press 2.
the ENTER button.
Rename the prole.3.
Use ▲ ▼ ◄ ► to specify the location of the required
character to enter and press the ENTER button.
Select 4. OK and press the ENTER button to set the
entered text as a name.
Loading saved proles
When proles are loaded under the PICTURE
MODE setting, you can keep them as you dened
until the PROFILE is set to NORMAL.
Select the required 1. PICTURE MODE and press
the ENTER button.
Press the 2. COLOR MANAGEMENT button and
select the PROFILE menu.
The prole settings of the selected PICTURE MODE
will be displayed.
Select the required prole and press the 3. ENTER
button.
NORMAL
Return to the default setting of the
PICTURE MODE menu.
USER1
Dened prole settings.USER2
USER3
NOTE:
In the • CURSOR mode, you can adjust the colors
except white, gray and black.
In the • CURSOR mode, if you adjust the exact same
color differently, both will affect each other and you
might get unexpected results.
COLOR MANAGEMENT • will be unable to adjust with
the setting of COLOR1 in PICTURE MODE, when
HDMI signal is selected.
If there is another area, which has an exact same or •
similar color with your target in the same screen, all
colors will be adjusted as well.
If you switch the input signal before you save the •
prole, the setting will be cancelled without notice.
J
x.v.Color
You can switch on/off the automatic adjustment
system for signals which comply with International
Standard xvYCC.
ON: Active
OFF: Deactive
NOTE:
x.v.Color • adjustment system is available only with
HDMI signals in COLOR1 of PICTURE MODE menu.