Chapter 4
Settings — [SECURITY] menu
ENGLISH - 105
f
The items will switch each time you press the button.
[OFF] Hides the security message.
[TEXT] Displays the text set in the [SECURITY] menu → [TEXT CHANGE].
[USER LOGO] Displays the image registered by the user.
Note
f
To create/register the [USER LOGO] image, use “Logo Transfer Software” included in the supplied CD-ROM.
[TEXT CHANGE]
Edit the text to be displayed when [TEXT] is selected in [DISPLAY SETTING].
1) Press as to select [TEXT CHANGE].
2) Press the <ENTER> button.
f
The [TEXT CHANGE] screen is displayed.
3) Press asqw to select the text, and press the <ENTER> button to enter the text.
4) Press asqw to select [OK], and press the <ENTER> button.
f
The text is changed.
[MENU LOCK]
Display the menu by the <MENU> button and set whether or not to enable menu operations.
1) Press as to select [MENU LOCK].
2) Press qw to switch the item.
f
The items will switch each time you press the button.
[OFF] Unlocks menu operations.
[ON] Locks menu operations.
Note
f
When the entered password is incorrect after setting [MENU LOCK] to [ON], the <MENU> button cannot be operated.
f
[MENU LOCK] is set to [OFF] at the time of purchase or when [INITIALIZE ALL] is executed.
f
When [MENU LOCK] is set to [ON], after entering the password to release the lock, the unlock state is held until the projector enters the
standby mode.
[MENU LOCK PASSWORD]
The menu lock password can be changed.
1) Press as to select [MENU LOCK PASSWORD].
2) Press the <ENTER> button.
f
The [MENU LOCK PASSWORD] screen is displayed.
3) Press asqw to select the text, and press the <ENTER> button to enter the text.
f
Up to 16 characters can be input.
4) Press asqw to select [OK], and press the <ENTER> button.
f
To cancel, select [CANCEL].
Attention
f
The initial password is “AAAA” at the time of purchase or when [INITIALIZE ALL] is executed.
f
Change the password periodically that is hard to guess.
[CONTROL DEVICE SETUP]
Enable/disable the button operations on the control panel and the remote control.
1) Press as to select [CONTROL DEVICE SETUP].
To Next Page
Loading...
