Panasonic PT-EZ590

Chapter 4 Settings — [DISPLAY OPTION] menu
88 - ENGLISH
4) Press qw to switch the item.
[KEEP CURRENT STATE] When the projector is switched off, the projector turns into standby with the shutter status left as is.
[OPEN] When the projector is switched off, the projector turns into standby with the shutter left opened.
[CLOSE] When the projector is switched off, the projector turns into standby with the shutter left closed.
[AUTO SETUP SETTING]
Set the automatic execution of AUTO SETUP.
The screen display position or signal level can be adjusted automatically without pressing the <AUTO SETUP>
button on the remote control on each occasion if you input unregistered signals frequently at meetings, etc.
1) Press as to select [AUTO SETUP SETTING].
2) Press qw to switch the item.
f
The items will switch each time you press the button.
[AUTO] Enables the auto setup function when switching signals.
[BUTTON] Enables the auto setup function only when the <AUTO SETUP> button is pressed.
[SIGNAL SEARCH]
When the power is turned on, this function automatically detects the terminal which signals are input and sets the
function to switch.
1) Press as to select [SIGNAL SEARCH].
2) Press qw to switch the item.
f
The items will switch each time you press the button.
[ON] Enables input detection automatically.
[OFF] Disables input detection automatically.
Note
f
If the [SIGNAL SEARCH] is set to [ON] when there is no signal input, press the <AUTO SETUP> button on the remote control, this function
automatically detects the terminal to which signals are input and then switches.
[STARTUP INPUT SELECT]
Set the input when the projector is switched on to start projection.
1) Press as to select [STARTUP INPUT SELECT].
2) Press the <ENTER> button.
f
The [STARTUP INPUT SELECT] screen is displayed.
3) Press as to select an item.
f
The items will switch each time you press the button.
[LAST USED] Keeps the input selected last.
[NETWORK] Sets the input to NETWORK.
[RGB1] Sets the input to RGB1.
[RGB2] Sets the input to RGB2.
[HDMI1] Sets the input to HDMI1.
[HDMI2] Sets the input to HDMI2.
[VIDEO] Sets the input to VIDEO.
[DIGITAL LINK]
*1
Sets the input to DIGITAL LINK.
[INPUT1] ~
[INPUT10]
*1*2
Sets the input to DIGITAL LINK, and switches the input of Panasonic twisted-pair-cable transmitter to the
specied input.
*1 Only for PT-EZ590, PT-EW650 and PT-EX620
*2 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its input name is
automatically reected from [INPUT1] to [INPUT10]. If an item where the input name is not reected is selected, it is disabled.
Note
f
When [SIGNAL SEARCH] is set to [ON], the [STARTUP INPUT SELECT] cannot be set.