Chapter 1
Preparation — About your projector
26 - ENGLISH
Attention
f
Do not drop the remote control.
f
Avoid contact with liquids or moisture.
f
Do not attempt to modify or disassemble the remote control.
f
Please observe the following contents that are described on the back of the remote
control unit (see the right picture).
1. Do not use a new battery together with an old battery.
2. Do not use unspecied batteries.
3. Make sure the polarities (+ and -) are correct when inserting the batteries.
f
In addition, please read the contents that are related to batteries in the "Read this rst!".
Caution label at the back of the remote control
Note
f
When operating the remote control by directly pointing the remote control signal receiver of the projector, operate the remote control at
a distance approx. 30 m (98'5") or shorter from the remote control signal receiver. The remote control can control at angles of up to ±30°
vertically and horizontally, but the effective control range may be reduced.
f
If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate properly.
f
The signal will be reected off the screen. However, the operating range may be limited from light reection loss due to the screen material.
f
If the remote control signal receiver directly receives strong light, such as uorescent light, the remote control may not operate properly. Use
it in a place distant from the light source.
f
The power indicator <ON (G)/STANDBY(R)> will blink if the projector receives a remote control signal.
Projector body
r Front
1 2 3 4 5
6
7 98 6
10
12 13 1514
18
16
10
17
11
r Side
r Rear
Projection direction
WARNING
Keep your hands and other objects away from the air
exhaust port.
f
Keep your hands and face away.
f
Do not insert your ngers.
f
Keep heat-sensitive objects away.
Heated air from the air exhaust port can cause burns, injury, or
deformations.
1 Remote control signal receiver (front)
2 Power indicator <ON (G)/STANDBY(R)>
Displays the status of the power.
3 Lamp indicator <LAMP>
Displays the status of the lamp.
4 Temperature indicator <TEMP>
Displays the status of the internal temperature.
5 Filter indicator <FILTER>
Displays the status of the air lter unit.
6 Adjustable feet
Adjusts the projection angle.
7 Speaker
8 Lens release button (x page 38)
9 Projection lens
(Only models with lens)
10 Air exhaust port
11 Remote control signal receiver (rear)
Connect the supplied power cord.
13 <MAIN POWER> switch
Turns off/on the main power.
14 Connecting terminals (x page 28)
15 Security slot
This security slot is compatible with the Kensington security
cables.
1. 请勿把旧电池和新电池一起使用。
2. 请勿使用不合规格的电池。
3. 确保电池安装正确。
原产地：中国
1.Do not use old battery with new one.
2.Do not use batteries other than the
type specified.
3.Be sure the batteries are inserted properly.
To Next Page
Loading...
