Panasonic PT-EZ590

Chapter 3 Basic Operations — Operating with the remote control
56 - ENGLISH
Note
f
If you press the <MENU> button on the control panel for at least three seconds while the on-screen display is off (hidden), the [OSD]
individual adjustment screen is displayed. Press
qw
to select [ON], then the on-screen display is turned on.
Using the automatic setup function
The automatic setup function can be used to automatically adjust the resolution, clock phase, and image position
when analog RGB signals consisting of bitmap images such as computer signals are being input. Supplying
images with bright white borders at the edges and high-contrast black and white characters is recommended when
the system is in automatic adjustment mode. Avoid supplying images that include halftones or gradation, such as
photographs and computer graphics.
button
1) Press the <AUTO SETUP> button.
Note
f
The clock phase may shift even if it has completed without any incident. In such cases, adjust the [POSITION] menu
→
[CLOCK PHASE]
(
x
page 78).
f
Automatic adjustment may not work depending on the model of the computer and the input signal. And, it may not work properly when the
input signal is a blurred-edge image or a dark image.
f
Images may be disrupted for a few seconds during automatic adjustment, but it is not a malfunction.
f
Adjustment is required for each input signal.
f
Automatic adjustment can be canceled by pressing the <MENU> button during the automatic adjustment operation.
f
If the automatic setup function is used while moving images are being input, the adjustment may not be performed properly even for an RGB
signal that can use automatic setup.
Using the SCREEN ADJ button
The [SCREEN ADJUSTMENT] screen can be displayed.
You can correct the distortion of the projected image that occurs when the projector is installed tilted or when the
screen is tilted or curved.
button
1) Press the <SCREEN ADJ> button to display [KEYSTONE] individual adjustment screen.
Or press the <SCREEN ADJ> button again to display [CORNER CORRECTION] individual adjustment
screen.
Or press the <SCREEN ADJ> button again to
display [CURVED CORRECTION] individual adjustment
screen.
f
If you have adjusted values in any of the individual adjustment screen, the individual adjustment screen is
not switched to the next screen even if you press the <SCREEN ADJ> button.
[KEYSTONE] Adjusts when the trapezoid of the projected image is distorted.
[CORNER CORRECTION] Adjusts when the four corners of the projected image are distorted.
[CURVED CORRECTION] Adjusts when the linearity is not uniform or the projected image is curved distortion.
2) Press <ENTER> button to select an item.
f
The items will switch each time you press the button.
3) Press asqw to adjust the value.
Note
f
One of [KEYSTONE], [CORNER CORRECTION] and [CURVED CORRECTION] setting value is valid.
f
For more details, refer to the [POSITION] menu → [SCREEN ADJUSTMENT]. (
x
page 71)