Chapter 4 Settings — [NETWORK] menu
ENGLISH - 105
[NETWORK] menu
On the menu screen, select [NETWORK] from the main menu, and select an item from the sub-
menu.
Refer to “Navigating through the menu” (x page 55) for the operation of the menu screen.
f After selecting the item, press asqw to set.
[DIGITAL LINK MODE]
Switch the communication method of the <DIGITAL LINK/LAN> terminal of the projector.
1) Press as to select [DIGITAL LINK MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO] Switches the communication method automatically to DIGITAL LINK or Ethernet.
[DIGITAL LINK] Fixes the communication method to DIGITAL LINK.
[ETHERNET] Fixes the communication method to Ethernet.
Possible communication modes
Setting
Communication possible
Image transmission Ethernet RS-232C
[AUTO]
For DIGITAL LINK
l l l
For Ethernet ―
l
―
[DIGITAL LINK]
l l l
[ETHERNET] ―
l
―
l: Communication possible
―: Communication not possible
[DIGITAL LINK SETUP]
Set the communication method of DIGITAL LINK or Ethernet.
When the projector is connected directly via Ethernet
1) Press as to select [DIGITAL LINK SETUP].
2) Press the <ENTER> button.
f The [DIGITAL LINK SETUP] screen is displayed.
3) Press as to select [DUPLEX(ETHERNET)].
4) Press qw to switch the communication method.
f The items will switch each time you press the button.
[AUTONEGOTIATION] The communication method is set automatically.
[100BaseTX-Full] Full-duplex communication method is set.
[100BaseTX-Half] Half-duplex communication method is set.
5) Press as to select [STORE].
6) Press the <ENTER> button.
To Next Page
Loading...
