Panasonic PT-EZ770 Series

Chapter 4 Settings — [PROJECTOR SETUP] menu
88 - ENGLISH
11) Press the <ENTER> button.
f The command is xed and n is displayed at the left of the selected command.
f After the command is xed, press the <MENU> button to close the detailed setting screen.
12) Press asqw to select [STORE], and press the <ENTER> button.
Note
f If you attempt to register the setting that would make the lamp turn on for a short time during the same day, an error message will be
displayed on the screen. Set the time and command again. If you set a schedule that would make the lamp turn on for a short time across
two or more days, an error message will not be displayed. When executing a command for turning the projector on, provide an interval of
at least four minutes between the [STANDBY] and the [POWER ON] command. When executing a command for setting the projector to
standby, provide an interval of at least 31 minutes between the [POWER ON] command and the [STANDBY] command.
f To delete a command already set, press the <DEFAULT> button on the remote control at the screen in Step 5), or select [DELETE] at the
screen in Step 6) and press the <ENTER> button.
f If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest command
number.
f The operating time will be the local time. (x page 93)
f If an operation is executed with the remote control or control panel of the projector or with a control command before the command set in
[SCHEDULE] is executed, the command set with this function may not be executed.
[STARTUP INPUT SELECT]
Set the input when the projector is switched on to start projection.
1) Press as to select [STARTUP INPUT SELECT].
2) Press the <ENTER> button.
f The [STARTUP INPUT SELECT] screen is displayed.
3) Press asqw to select an input.
f The items will switch each time you press the button.
[LAST USED] Keeps the input selected last.
[VIDEO] Sets the input to VIDEO.
[RGB1] Sets the input to RGB1.
[RGB2] Sets the input to RGB2.
[DVI-D] Sets the input to DVI-D.
[HDMI] Sets the input to HDMI.
[DIGITAL LINK] Sets the input to DIGITAL LINK.
[DisplayPort] Sets input to DisplayPort.
[INPUT1] - [INPUT10]
*1
Sets the input to DIGITAL LINK, and switches the input of the DIGITAL LINK output supported device
to the specied input.
*1 When the optional DIGITAL LINK output supported device (such as the optional Digital Interface Box (Model No.: ET-YFB100G)) is connected
to the projector, its input name is reected from [INPUT1] to [INPUT10] automatically. If an item where the input name is not reected is
selected, it is disabled.
4) Press the <ENTER> button.
[RS-232C]
Set the communication conditions of the <SERIAL IN> terminal.
Setting the communication condition of the <SERIAL IN> terminal
1) Press as to select [RS-232C].
2) Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3) Press as to select [INPUT SELECT].
4) Press qw to switch the item.
[PROJECTOR] Use the <SERIAL IN> terminal of the projector to execute RS-232C communication.
[DIGITAL INTERFACE BOX]
Executes RS-232C communication via the optional Digital Interface Box (Model No.: ET-YFB100G)
and the <DIGITAL LINK/LAN> terminal.
5) Press as to select [BAUDRATE].