Chapter 4 Settings — [PROJECTOR SETUP] menu
90 - ENGLISH
[REMOTE2 MODE]
Set the <REMOTE 2 IN> terminal.
1) Press as to select [REMOTE2 MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT]
The pin assignment of the <REMOTE 2 IN> terminal is used by the factory default setting of the
projector.
[USER] Used to change the setting of the <REMOTE 2 IN> terminal.
[F/W SERIES] The setting of the <REMOTE 2 IN> terminal is used for the F/W series compatibility.
f When [USER] is selected, proceed to Step 3).
3) Press the <ENTER> button.
4) Press as to select one from [PIN2] to [PIN8], and press qw to switch the setting.
[FUNCTION BUTTON]
Set the functions of the <FUNCTION> button on the remote control.
1) Press as to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3) Press as to select a function.
[DISABLE] Disables the <FUNCTION> button.
[SUB MEMORY]
Displays the sub memory list. (x page 101)
[SYSTEM SELECTOR]
Switches the [SYSTEM SELECTOR] setting. (x page 64)
[DAYLIGHT VIEW]
Switches the [DAYLIGHT VIEW] setting. (x page 64)
[TEST PATTERN]
Displays the test pattern built-in to the projector. (x page 98)
4) Press the <ENTER> button.
[AUDIO SETTING]
Set audio functions in detail.
Adjusting the volume
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [VOLUME].
4) Press qw to adjust the level.
Operation Adjustment Range of adjustment
Press w.
Increases the volume.
0 - 63
Press q.
Decreases the volume.
Adjusting the left to right audio balance
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [BALANCE].
To Next Page
Loading...
