Chapter 3 Basic Operations — Operating with the remote control
50 - ENGLISH
Attention
f When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [SHUTTER DETECTION] is set to [ON], do not switch the shutter on
(closed)/off (open) in a short time.
Note
f The power indicator <ON (G)/STANDBY (R)> will ash slowly in green while the shutter function is in use.
Using the mute function
Audio can be temporarily turned off.
button
1) Press the <MUTE> button.
f The audio disappears.
2) Press the <MUTE> button again.
f The audio reappears.
Adjusting the volume
The volume of the built-in speaker or audio output can be adjusted.
button
1) Press the <VOL
-
> button/<VOL+> button on the remote control.
f This operation can be also performed using the <VOL-> button/<VOL+> button on the control panel.
<VOL+> Increases the volume.
<VOL
-
> Decreases the volume.
Using the freeze function
The projected image can be paused and audio turned off regardless of the playback of the external device.
button
1) Press the <FREEZE> button.
f The image freezes and audio disappears.
2) Press the <FREEZE> button again.
f Freezing of the image is canceled and audio reappears.
Note
f [FREEZE] is displayed on the screen when video is paused.
Using the on-screen display function
Turn off the on-screen display function (no display) when you do not wish the viewers to see the on-screen display, such as the menu or the
input terminal name.
button
1) Press the <ON SCREEN> button.
f The on-screen display disappears.
2) Press the <ON SCREEN> button again.
f The on-screen display appears.
To Next Page
Loading...
