Chapter 1 Preparation — About your projector
22 - ENGLISH
About your projector
Remote control
1
3
2
4
5
8
7
6 6
9
10
16
17
18
19
15
11
13
20
22
21
24
23
12
14
25
26
Front Top
Bottom
1 Power standby <v> button
Sets the projector to the state where the projector is switched
off (standby mode) when the <MAIN POWER> switch on the
projector is set to <ON> and in the projection mode.
2 Power on <b> button
Starts projection when the <MAIN POWER> switch on the
projector is set to <ON> when the power is switched off
(standby mode).
3 Remote control indicator
Flashes if any button in the remote control is pressed.
4 Lens (<FOCUS>, <ZOOM>, <SHIFT>) buttons
Adjusts the Projection Lens. (x page 47)
5 <MENU> button/<ENTER> button/asqw button
Used to navigate through the menu screen. (x page 55)
6 <VOL
-
> button/<VOL+> button
Adjusts the volume of the built-in speaker or audio output.
(x page 50)
7 <ON SCREEN> button
Switches on (display)/off (hide) the on-screen display function.
(x page 50)
8 Input selection (<RGB1/2>, <DIGITAL LINK>, <DVI-D>,
<VIDEO>, <DisplayPort>, <HDMI>) buttons
Switches the input signal to project. (x page 49)
9 Number (<0> - <9>) buttons
Used when the system uses multiple projectors.
Used to input ID numbers or passwords.
10 <ID ALL> button
Used to simultaneously control all the projectors with a single
remote control when using multiple projectors. (x page 26)
11 <ECO> button
Displays the setting screen relating to ECO management.
(x pages 53, 85)
12 <SHUTTER> button
Used when temporarily turning off the image and audio.
(x page 49)
Automatically adjusts the image display position while the
image is projected.
[PROGRESS] is displayed on the screen while adjusting
automatically. (x page 51)
14 <ID SET> button
Sets the ID number of the remote control to use for a system
using multiple projectors. (x page 26)
15 <KEYSTONE> button
Displays the [KEYSTONE] menu. (x pages 51, 68)
16 <FUNCTION> button
Assigns a frequently used operation as a shortcut button.
(x page 53)
17 <FREEZE> button
Used when pausing the image and turning off the audio.
(x page 50)
Operates the presentation timer function. (x page 51)
19 <STATUS> button
Displays the status of the projector. (x pages 53, 92)
20 <DEFAULT> button
Resets the content of the sub-menu to the factory default.
(x page 56)
21 <D.ZOOM> button
Displays the [DIGITAL ZOOM] menu. (x pages 52, 82)
22 <MUTE> button
Used when temporarily turning off the audio. (x page 50)
Switches the aspect ratio of the image. (x page 52)
Switches the [P IN P] setting. (x page 52)
25 Remote control signal transmitter
26 Remote control wired terminal
This is the terminal to connect to the projector by a cable when
used as a wired remote control. (x page 27)
Attention
f Do not drop the remote control.
To Next Page
Loading...
