Chapter 4 Settings — [DISPLAY OPTION] menu
ENGLISH - 81
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [SHUT-OFF].
4) Press qw to switch the item.
[KEEP CURRENT STATE] When the projector is switched off, the projector turns into standby with the shutter status as is.
[OPEN] When the projector is switched off, the projector turns into standby with the shutter left opened.
[CLOSE] When the projector is switched off, the projector turns into standby with the shutter left closed.
[P-TIMER]
Set and operate the presentation timer function.
Setting the mode
1) Press as to select [P-TIMER].
2) Press the <ENTER> button.
f The [P-TIMER] screen is displayed.
3) Press as to select [MODE].
4) Press qw to switch the item.
[COUNT UP] Displays the elapsed time since the count was started.
[COUNT DOWN] Displays the remaining time of the time set by [TIMER].
Setting the timer
1) Press as to select [P-TIMER].
2) Press the <ENTER> button.
f The [P-TIMER] screen is displayed.
3) Press as to select [TIMER].
4) Press qw to set the time.
f The time can be set in 1-minute increments from 1 to 180 minutes.
f The factory default value is 10 minutes.
Note
f [TIMER] is enabled when [MODE] is set to [COUNT DOWN].
Using the presentation timer
1) Press as to select [P-TIMER].
2) Press the <ENTER> button.
f The [P-TIMER] screen is displayed.
3) Press as to select the item, and press the <ENTER> button.
[START] The count is started.
[STOP] The count is stopped.
[RESTART] The count is resumed.
[RESET] The count is reset.
f When [START] or [RESTART] is selected, the elapsed time or the remaining time is displayed at the bottom right of the projected
image.
f When [STOP] is selected, the elapsed time or the remaining time when the count was stopped is displayed at the bottom right of the
projected image.
f When [RESET] is selected, proceed to Step 4).
To Next Page
Loading...
