Chapter 4 Settings — [DISPLAY OPTION] menu
ENGLISH - 73
[DISPLAY OPTION] menu
On the menu screen, select [DISPLAY OPTION] from the main menu, and select an item from
the sub-menu.
Refer to “Navigating through the menu” (x page 55) for the operation of the menu screen.
f After selecting the item, press asqw to set.
[COLOR ADJUSTMENT]
Correct the color difference between projectors when using multiple projectors simultaneously.
1) Press as to select [COLOR ADJUSTMENT].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] Color adjustment is not carried out.
[3COLORS] Adjusts the three colors [RED], [GREEN], or [BLUE].
[7COLORS] Adjusts the seven colors [RED], [GREEN], [BLUE], [CYAN], [MAGENTA], [YELLOW], or [WHITE].
3) Select [3COLORS] or [7COLORS], and press the <ENTER> button.
f The [3COLORS] or [7COLORS] screen is displayed.
4) Press as to select [RED], [GREEN], or [BLUE] ([RED], [GREEN], [BLUE], [CYAN], [MAGENTA],
[YELLOW], or [WHITE] for [7COLORS]).
5) Press the <ENTER> button.
f The [3COLORS:RED], [3COLORS:GREEN], or [3COLORS:BLUE] screen is displayed.
For [7COLORS], the [7COLORS:RED], [7COLORS:GREEN], [7COLORS:BLUE], [7COLORS:CYAN], [7COLORS:MAGENTA],
[7COLORS:YELLOW], or [7COLORS:WHITE] screen is displayed.
f Set [AUTO TESTPATTERN] to [ON] to display a test pattern of selected colors.
6) Press as to select [RED], [GREEN], or [BLUE].
7) Press qw to adjust.
f The adjustment value changes between 0
*1
and 2 048.
*1 The lower limit varies depending on the adjusting color.
Note
f Operation when correcting the adjustment color
When the correction color same as the adjustment color is changed: The luminance of the adjustment color changes.
When correction color red is changed: Red is added to or subtracted from the adjustment color.
When correction color green is changed: Green is added to or subtracted from the adjustment color.
When correction color blue is changed: Blue is added to or subtracted from the adjustment color.
f This adjustment should be carried out by a person who is familiar with the projector or by a service person because a high level of skill is
required to make a successful adjustment.
f Set the [AUTO TESTPATTERN] to [ON] to automatically display a test pattern for use in adjusting the selected adjustment colors.
f Pressing the <DEFAULT> button on the remote control will restore the factory default settings for all items.
f If [COLOR ADJUSTMENT] is set to other than [OFF], [COLOR CORRECTION] is xed to [OFF], and [COLOR TEMPERATURE] is xed to
[USER]. (However, [WHITE BALANCE HIGH] cannot be adjusted.)
[COLOR CORRECTION]
Colors can be adjusted and registered for each input signal format.
1) Press as to select [COLOR CORRECTION].
2) Press qw to switch the item.
f The items will switch each time you press the button.
To Next Page
Loading...
