Panasonic PT-EZ770 Series

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 87
2) Press qw to select [ON], and press the <ENTER> button.
f The [SCHEDULE] screen is displayed.
3) Select and assign program to each day of week.
f Press as to select the day of week, and press qw to select a program number.
f You can set the program from No.1 to No.7. “- - -” indicates that the program number has not been set.
How to set a program
Set up to 16 commands to each program.
1) Press as to select [SCHEDULE].
2) Press qw to select [ON], and press the <ENTER> button.
f The [SCHEDULE] screen is displayed.
3) Press as to select [PROGRAM EDIT].
4) Press qw to select a program number, and press the <ENTER> button.
5) Press as to select a command number, and press the <ENTER> button.
f You can change the page using qw.
6) Press asqw to select [TIME], and press the <ENTER> button.
7) Press qw to select “hour” or “minute”, and press as or the number (<0> - <9>) buttons to set a
time, and then press the <ENTER> button.
8) Press asqw to select [COMMAND].
9) Press the <ENTER> button.
f The [COMMAND] detailed screen is displayed.
10) Press as to select a [COMMAND].
f For [COMMAND] which requires detailed settings, the items of the detailed settings will switch each time you press qw.
f When [INPUT] is selected, press the <ENTER> button, and then press asqw to select the input to set.
[COMMAND]
Detailed settings of
[COMMAND]
Description
[POWER ON] ― Switches on the projector.
[STANDBY] ― Enters standby.
[SHUTTER]
[OPEN] Opens the shutter.
[CLOSE] Closes the shutter.
[INPUT]
[VIDEO] Switches the input to VIDEO.
[RGB1] Switches the input to RGB1.
[RGB2] Switches the input to RGB2.
[DVI-D] Switches the input to DVI-D.
[HDMI] Switches the input to HDMI.
[DIGITAL LINK] Switches the input to DIGITAL LINK.
[DisplayPort] Switches the input to DisplayPort.
[INPUT1] - [INPUT10]
*1
Switches the input to DIGITAL LINK, and switches the input of the
DIGITAL LINK output supported device to the specied input.
[LAMP POWER]
[AUTO] Sets [LAMP POWER] to [AUTO].
[NORMAL] Sets [LAMP POWER] to [NORMAL].
[ECO1] Sets [LAMP POWER] to [ECO1].
[ECO2] Sets [LAMP POWER] to [ECO2].
[P IN P]
[OFF] P IN P function is not used.
[USER1] Lays out the sub-screen with the settings of [USER1].
[USER2] Lays out the sub-screen with the settings of [USER2].
[USER3] Lays out the sub-screen with the settings of [USER3].
[IN STANDBY MODE(AUDIO)]
[OFF] Audio output is stopped during standby.
[ON] Audio is output during standby.
[VOLUME] [0] - [63] Sets the volume.
*1 When the optional DIGITAL LINK output supported device (such as the optional Digital Interface Box (Model No.: ET-YFB100G)) is connected
to the projector, its input name is reected from [INPUT1] to [INPUT10] automatically. If an item where the input name is not reected is
selected, it is disabled.