Panasonic PT-EZ770 Series

Chapter 1 Preparation — About your projector
ENGLISH - 25
r Connecting terminals
1 2 3 4 5 6 7 8
9 1110 12 13
1 <DIGITAL LINK/LAN> terminal
This is the LAN terminal to connect to the network. This is also
used when connecting a device for transmitting video and audio
signals via the LAN terminal.
2 <HDMI IN> terminal
This is the terminal to input HDMI signals.
3 <REMOTE 1 IN> terminal
This is the terminal to connect to the remote control by cable
when controlling the projector by wired remote control.
4 <MONITOR OUT> terminal
This is the terminal to output analog RGB signals and YC
B
C
R
/
YP
B
P
R
signals that were input to the <RGB 1 IN> or <RGB 2
IN> terminal to an external device. When the input is switched
to RGB1 or RGB2, the corresponding signals are output.
5 <RGB 1 IN> terminal
This is the terminal to input RGB signals or YC
B
C
R
/YP
B
P
R
signals.
6 <RGB 2 IN> (<R/P
R
>, <VIDEO/G/Y>, <B/P
B
/C>, <SYNC/HD>,
<VD>) terminal
This is the terminal to input RGB signals or YC
B
C
R
/YP
B
P
R
signals, Y/C signals, and video signals.
7 <DVI-D IN> terminal
This is the terminal to input DVI-D signals.
8 <DisplayPort IN> terminal
This is the terminal to input DisplayPort signals.
9 <VIDEO IN> terminal
This is the terminal to input video signals.
10 <AUDIO IN 1> terminal /<AUDIO IN 2> terminal/<AUDIO IN
3> terminal
This is the terminal to input audio. Left input <L> and right input
<R> are provided for the <AUDIO IN 3> terminal.
11 <VARIABLE AUDIO OUT> terminal
This is the terminal to output the input audio signal to the
projector.
12 <SERIAL IN> terminal
This is the RS-232C compatible terminal to externally control
the projector by connecting a computer.
13 <REMOTE 2 IN> terminal
This is the terminal to remotely control the projector using the
external control circuit.
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.