Panasonic PT-RZ575

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 101
[ECO MANAGEMENT]
Set the ECO management function to reduce the power consumption depending on the usage condition.
Setting [AUTO POWER SAVE]
Enable/disable the [AMBIENT LIGHT DETECTION] and [NO SIGNAL LIGHTS-OUT] functions.
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3) Press as to select [AUTO POWER SAVE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] Disables the auto power save setting.
[ON] Enables the auto power save setting.
5) Press as to select [AMBIENT LIGHT DETECTION] or [NO SIGNAL LIGHTS-OUT].
[AMBIENT LIGHT
DETECTION]
Adjusts the power of the light source in accordance with the brightness of the installed location.
[NO SIGNAL LIGHTS-OUT]
Automatically turns off the light source of the projector when there is no input signal for specic
period.
6) Press qw to switch the item.
f The items will switch each time you press the button.
[AMBIENT LIGHT
DETECTION]
[OFF] Disables the ambient light detection function.
[ON] Enables the ambient light detection function.
[NO SIGNAL LIGHTS-OUT]
[DISABLE] Disables the no signal lights-out function.
[10SEC.] - [5MIN.]
Turns off the light source when there is no input signal for the preset
period.
Select [10SEC.], [20SEC.], [30SEC.], [1MIN.], [2MIN.], [3MIN.], or
[5MIN.].
Note
f [AMBIENT LIGHT DETECTION] and [NO SIGNAL LIGHTS-OUT] cannot be set when [AUTO POWER SAVE] is set to [OFF].
f The power indicator <ON (G)/STANDBY (R)> will blink slowly in green while the no signal lights-out function is operating and the light source
is turned off.
f When [NO SIGNAL LIGHTS-OUT] is set to anything other than [DISABLE], the conditions to turn on the light source again from the condition
that the light source was turned off by this function are as follows.
g When the signal has been input
g When on-screen display such as menu screen (OSD) or input guide, a test pattern, or a warning message is displayed
g When the power <v/b> button is pressed
g When the operation to disable the shutter function (shutter: open) is performed, such as pressing the <SHUTTER> button
g When the operating environment temperature is around 0 °C (32 °F) and the light source is forced to turn on due to warm-up
f The luminance may not be detected correctly when an object is placed on top of the projector, blocking the luminance sensor. In such a
case, it may not operate properly even if [AMBIENT LIGHT DETECTION] is set to [ON].
Setting [NO SIGNAL SHUT-OFF]
This is a function to automatically set the power of the projector to standby mode when there is no input signal for
specic period. The time before switching to standby can be set.
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3) Press as to select [NO SIGNAL SHUT-OFF].
4) Press qw to switch the item.
f The items will switch each time you press the button.