Chapter 1 Preparation — About your projector
26 - ENGLISH
Projector body
1 2 3
4
6 6
8
7
5
7 7 7
14 15
12
11
8 9
13
Front
Side
Rear
16710
Projection direction
BottomTop
1 Remote control signal receiver (front)
2 Power indicator <ON (G)/STANDBY (R)>
Indicates the status of the power.
3 Light source indicator <LIGHT>
Indicates the status of the light source.
4 Temperature indicator <TEMP>
Indicates the internal temperature status.
5 Projection lens
6 Adjustable feet
Adjusts the projection angle.
7 Air intake port
8 Air exhaust port
9 Remote control signal receiver (rear)
10 Luminance sensor
This is a sensor to detect the luminance of the installed
environment.
When the [PICTURE] menu → [DAYLIGHT VIEW] is set to
[AUTO], the luminance of the installed environment is detected
by the luminance sensor to automatically perform appropriate
picture quality correction.
11 Control panel (x page 27)
12 Connecting terminals (x page 27)
13 Security slot
This security slot is compatible with the Kensington security
cables.
14 <MAIN POWER> switch
Turns on/off the main power.
To Next Page
Loading...
