Panasonic PT-RZ575

Chapter 4 Settings — [DISPLAY OPTION] menu
96 - ENGLISH
Note
f To create/register the [USER LOGO] image, use “Logo Transfer Software” included in the supplied CD-ROM.
[STARTUP LOGO]
Set the logo display when the power is turned on.
1) Press as to select [STARTUP LOGO].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT LOGO] Displays the Panasonic logo.
[USER LOGO] Displays the image registered by the user.
[NONE] Disables the startup logo display.
Note
f When [USER LOGO] is selected, the display of the startup logo will be kept for approximately 15 seconds.
f To create/register the [USER LOGO] image, use “Logo Transfer Software” included in the supplied CD-ROM.
f If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP] is set to [ON], the startup logo is not displayed when
projection starts before the specied time elapses after the projector enters the standby mode.
The specied time is a time set in the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP] → [VALID PERIOD].
[UNIFORMITY]
Correct the brightness and color unevenness of the entire screen.
Setting each color
1) Press as to select [UNIFORMITY].
2) Press the <ENTER> button.
f The [UNIFORMITY] screen is displayed.
3) Press as to select [WHITE], [RED], [GREEN], or [BLUE].
4) Press qw to adjust the level.
Item Operation Adjustment Range of adjustment
[VERTICAL]
Press w.
The lower-side color becomes
pale, or the upper-side color
becomes dark.
- 127 - +127
Press q.
The upper-side color becomes
pale, or the lower-side color
becomes dark.
[HORIZONTAL]
Press w.
The left-side color becomes pale,
or the right-side color becomes
dark.
Press q.
The right-side color becomes
pale, or the left-side color
becomes dark.
Setting [PC CORRECTION]
Set the [PC CORRECTION] function to correct the brightness and the color unevenness of the entire screen using
a computer.
To use the [PC CORRECTION] function, an optional software application is required. Consult your dealer.
1) Press as to select [UNIFORMITY].
2) Press the <ENTER> button.
f The [UNIFORMITY] screen is displayed.
3) Press as to select [PC CORRECTION].
4) Press qw to switch the item.