Panasonic PT-VW350

About your projector
Remote control
1 Power <v/b> button
Turn the projector on or off. (x pages 36, 39)
(v standby / b power on)
2 Input Selection Buttons: <COMPUTER 1>,
<COMPUTER 2>, <HDMI>, <VIDEO>, <S-VIDEO>
These buttons are used to select the input signal.
(x page 40)
3 asqw Buttons, <ENTER> Button
Navigate the MENU display.
4 <DEFAULT> Button
Resets the content of the sub-menu to the factory default
(x page 48). Or deletes one character when you enter
an IP address or a text.
5 <MENU> Button
Open or close the On-Screen Menu. (x page 47)
6 <ID SET> Button
Sets the ID number of the remote control to use for a
system using multiple projectors. (x page 23)
7 <FREEZE> Button
Pauses the projected image and mute the audio
temporarily. (x page 42)
8 <D.ZOOM +/-> Buttons
Zoom in and out the images. (x page 43)
9 <VOL +/-> Buttons
Adjust the volume of the speaker. (x page 44)
10 <KEYSTONE> Button
Correct keystone distortion. (x page 41)
11 <P IN P> Button (Only for PT-VW350)
Operate the P IN P function.
12 Number buttons
Act as number buttons. Use these buttons when setting
the remote control codes or entering the password.
13 <AV MUTE> Button
Used to turn off the audio and video temporarily.
(x page 43)
14 <P-TIMER> Button
Operate the P-timer function. (x page 43)
15 <MUTE> Button
Used to mute the audio. (x page 44)
16 <ID ALL> Button
Used to simultaneously control all the projectors with
one remote control for a system using multiple projectors.
(x page 23)
17 <RETURN> Button
Return to the previous menu or cancel the setting.
18 <FUNCTION> Button
Assigns a frequently used operation as a shortcut button.
19 <AUTO SETUP> Button
Automatically adjusts the image display position while
projecting the image. (x page 41)
20 Remote control signal emitter
1
2
3
5
7
8
9
4
6
10
11
13
14
15
16
17
18
19
20
12
ENGLISH - 19
Chapter 1 Preparation - About your projector