Panasonic PT-VW350

[AUTO SETUP SETTING]
Set the automatic execution of AUTO SETUP.
The screen display position or signal level can be adjusted automatically without pressing the <AUTO SETUP> button on the
remote control or on the control panel on each occasion if you input unregistered signals frequently at meetings, etc.
1) Press as to select [AUTO SETUP SETTING].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO] Enables the auto setup function when switching signals.
[BUTTON] Enables the auto setup function only when the <AUTO SETUP> button is pressed.
[SIGNAL SEARCH]
When the power is turned on, this function automatically detects the terminal which signals are input and sets the function to
switch.
1) Press as to select [SIGNAL SEARCH].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[ON] Enables input detection automatically.
[OFF] Disables input detection automatically.
Note
f If the [SIGNAL SEARCH] is set to [ON] when there is no signal input, press the <AUTO SETUP> button on the remote
control or on the control panel, this function automatically detects the terminal to which signals are input and then switches.
[BACK COLOR]
Set the display of the projected screen when there is no signal input.
1) Press as to select [BACK COLOR].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[BLUE] Displays the entire projection area in blue.
[BLACK] Displays the entire projection area in black.
[DEFAULT LOGO] Displays the Panasonic logo.
[USER LOGO] Displays the image registered by the user.
Note
f To create/register the [USER LOGO] image, use “Logo Transfer Software” included in the supplied CD-ROM.
f If you do not register the image of the [USER LOGO], the projected image will be displayed in black even if the [BACK
COLOR] is set to [USER LOGO].
[WIDE MODE]
Using this function when displays the incorrect signals input.
1) Press as to select [WIDE MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO] Displays by judging the signal automatically. Set to this mode normally.
[ON] When input the wide signal.
[OFF] When input the 4:3 signal.
[SXGA MODE]
This function is used if the whole projected image is not displayed when SXGA signal is input. Set it to [SXGA] normally.
1) Press as to select [SXGA MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[SXGA] Normal setting.
[SXGA +] Set this when the edge of the image is cropped.
ENGLISH - 65
Chapter 4 Settings - [DISPLAY OPTION] menu