[NAME CHANGE]
You can change the projector name, for example, when using the DHCP server.
1) Press as to select [NAME CHANGE].
2) Press the <ENTER> button.
f The [NAME CHANGE] screen is displayed.
3) Select characters with the asqw buttons and press the <ENTER> button to enter the projector
name.
f Select [ALL DELETE] to delete all the entered characters, or press the <DEFAULT> button on the remote control to
delete a character on the cursor in the entry eld.
4) Select [OK] with the as buttons and press the <ENTER> button.
f To cancel the change of the name, select [CANCEL] and press the <ENTER> button.
Note
f [Name □□□□] (□□□□ is 4-digit number) is set before the projector leaves the factory.
[NETWORK CONTROL]
Set when you want to control the projector from a computer connected to the network.
1) Press as to select [NETWORK CONTROL].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[ON] This function is enabled. Web control, PJLink control, the command control of the LAN are enabled.
[OFF] This function is disabled.
[AMX D.D.]
Set to [ON] to control with the controller of AMX Corporation.
Setting this function to [ON] enables detection through “AMX Device Discovery”. For details, refer to the website of AMX
Corporation.
URL http://www.amx.com/
1) Press as to select [AMX D.D.].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] This function is disabled.
[ON] This function is enabled.
[Crestron Connected(TM)]
Set to [ON] to control with Crestron Connected™ of Crestron Electronics, Inc.
1) Press as to select [Crestron Connected(TM)].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] This function is disabled.
[ON] This function is enabled.
80 - ENGLISH
Chapter 4 Settings - [NETWORK] menu
To Next Page
Loading...
