Panasonic PT-VX425N

Powering on/off
Connecting the power cord
Make sure that the supplied power cord is securely xed to the projector body to prevent it from being removed
easily.
For details of power cord handling, refer to “Read this rst!” (x page 2).
Attaching
1) Check the shapes of the <AC IN> terminal on the back of the projector body and the power cord
connector and insert the plug completely in the correct direction (until you hear the side tabs click in
place).
Removing
1) Confirm that the projector is in standby mode, and remove the power plug from the outlet.
2) Remove the power cord connector from the <AC IN> terminal of the projector body while pressing the
side tabs.
Power indicator
The power indicator <ON(G)/STANDBY(R)> informs you the status of the power. Conrm the status of the power indicator
<ON(G)/STANDBY(R)> before operating the projector.
Power indicator <ON(G)/STANDBY(R)>
Indicator status Status
Off The power cord is unplugged.
Red
Lit
The power is switched off (in standby mode). The
[PROJECTOR SETUP] menu x [ECO
MANAGEMENT] x
[STANDBY MODE] is set to [ECO].
Blinking
The power is switched off (in standby mode). The
[PROJECTOR SETUP] menu x [ECO
MANAGEMENT] x
[STANDBY MODE] is set to [NETWORK].*
1
The power is switched off (in standby mode). The [PROJECTOR SETUP] menu x [ECO
MANAGEMENT] x
[STANDBY MODE] is set to [NORMAL].*
2
Orange Lit
The projector is cooling down.
The power is switched off after a while. (Changes to the standby mode.)
ENGLISH - 41
Chapter 3 Basic Operations - Powering on/off