Panasonic PT-VX425N

[PROJECTOR SETUP] menu
On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the sub-menu.
Refer to "Navigating through the menu" (x page 56) for the operation of the menu screen.
fAfter selecting the item, press asqw to set.
[STATUS]
You can check the using status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
[SIGNAL]
[NAME] Displays the name of input signal.
[FREQUENCY] Displays the scanning frequency of input signal.
[RUNTIME]
*
1
[PROJECTOR] Displays the current usage time of projector.
[LAMP (ET-LAV300*
2
)]
Displays the model No. of the replacement lamp unit for this
projector.
[NORMAL]
Displays the lamp runtime when [LAMP POWER] is set to
[NORMAL] by actual time.
[ECO]
Displays the lamp runtime when [LAMP POWER] is set to [ECO]
by actual time.
[SERIAL NUMBER] [PROJECTOR] Displays the serial number of the projector.
*1 The following conversion is required to calculate the rough estimate for lamp replacement.
Formula for lamp replacement time (rough estimate)
A ×1 + B × 5/7
f A : Runtime which is displayed in [STATUS] screen - [RUNTIME] - [LAMP] - [NORMAL]
f B : Runtime which is displayed in [STATUS] screen - [RUNTIME] - [LAMP] - [ECO]
*2 The model No. of the optional lamp unit is subject to change without prior notice.
Note
f If you attach a lamp unit used in a projector of a model different from the projector (PT-VW355N, PT-VX425N) to the
projector, or when the lamp unit used in the projector to a projector of a different model, the [RUNTIME] displayed in
[STATUS] may differ from the actual time.
[COMPUTER2 SELECT]
Set whether to use the <COMPUTER 2 IN/1 OUT> terminal.
1) Press as to select [COMPUTER2 SELECT].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[COMPUTER2 IN] When input the computer signal.
[COMPUTER1 OUT] Outputs the signal which have been input <COMPUTER 1 IN> terminal.
Note
f The [COMPUTER2 SELECT] will be unavailable when [COMPUTER2] is selected as input source.
ENGLISH - 77
Chapter 4 Settings - [PROJECTOR SETUP] menu