44
<Procedure of CZ-RTC5B>
Refer to Section “Flap Setting for Each Air Outlet” in the Operating Instructions attached
to the optional High-spec Wired Remote Controller.
<Procedure of CZ-RTC4>
Stop the system before performing these steps.
1
Press and hold the
, and buttons
simultaneously for 4 seconds or longer.
2
If group control is in effect, press the
button
to set. At this time, the fan at the indoor unit
begins and select the address (unit No.) of the
indoor unit operating.
3
Designate the item code “XX” by adjusting the
Temperature Setting
/ buttons.
XX=90
XX=91
XX=92
XX=93
(Outlet 1)
(Outlet 3)
(Outlet 2) (Outlet 4)
The square mark
(indented
)
4
Press the timer time
/ buttons to select the desired setting data.
* Setting data “YYYY”
Setting data Flap position during operation
Without separate setting
Swing
Move to position
1
and stay
Move to position
2
and stay
Move to position
3
and stay
Move to position
4
and stay
Move to position
5
and stay
NOTE
The flap swings during the operation under “Setting the Flap Separately”.
At this time, the unselected flaps are moved to the position 1
.
5
Press the
button.
(The display stops blinking and remains lit, and setting is completed.)
If you wish to change the selected indoor unit, follow Step
2
.
6
Press the
button to return to normal remote controller display.
A
°
°
5
6
2
2
4
3
4
YYYY
XX
1
1
2
3
4
5
Flap position
01_330918_EU_Eng.indb 44 2021/9/9 11:26:55
To Next Page
Loading...
