Panasonic S-36MK2E5A - Page 103

3-27
Control of VRF SYSTEM
1
2
3
4
5
6
7
8
9
2. Instrallation Instractions
8
(EN)
1
Remove the bottom case.
Attention
Mounting the bottom case
zTighten the screws securely until
the screw heads touch the bottom case. (Otherwise, loose screw heads may hit the PCB and cause malfunction when mounting the top case.)
zDo not over-tighten the screws.
(The bottom case may be deformed, resulting in fall of the unit.)
Connecting the remote control wiring
zArrange the wires as shown in the illustration for  in
step 2, avoiding unnecessary wires being stored in the remote controller case. (Caught wires may destroy the PCB.)
zAvoid wires touching parts on the PCB.
(Caught wires may destroy the PCB.)
2
Mount to the wall.
Flat-blade screwdriver
Insert the driver and slightly turn.
Bottom case
Mounting
Exposed type
1
3
2
Mount the top case.
zAlign the claws of the top
case and then align the claws of the bottom case.
Preparation: Make 2 holes for screws using a driver.
Mount the bottom case to the wall.
Cut here with a nipper and remove the burr with a ¿ le.
Claw (2 places)
Wood screw (supplied)
Hole for screw
Claw (2 places)
Wall to which the remote controller is ¿ xed
Connect the remote control wiring
zArrange the wires along the groove
of the case.
Clamper
(supplied)
Pass through the hole
Remote controller terminal board
Remove the coating. Approx. 6 mm
Remove the sheath. Approx. 180 mm
Make sure the wiring connection is in the correct direction.
Bottom case (Back side)
Top case (Back side)
業務用リモコンCZ-RTC3据付書En.indd8 2014/01/2711:22:25
9
(EN)
(mm)
2323
83.5
5-5x9
120
120
16
Embedded type
Preparation: Make 2 holes for screws using a driver.
1
3
2
Connect the remote control wiring
Mount the top case.
zAlign the claws of the
top case and then align the claws of the bottom case.
Avoid the wire being caught.
Claw (2 places)
Wood screw (supplied)
Hole for screw
Claw (2 places)
Mount the bottom case to the wall.
zPass the wire through the hole in the centre
of the bottom case.
Remote controller terminal board
Remove the coating. Approx. 6 mm
Make sure the wiring connection is in the correct direction.
Bottom case (Back side)
Top case (Back side)
Dimensions
ENGLISH
業務用リモコンCZ-RTC3据付書En.indd9 2014/01/2414:25:05
TD831172-00VRFSYSINDOOR.indb27TD831172-00VRFSYSINDOOR.indb27 2014/06/1316:54:482014/06/1316:54:48