Panasonic S-36MK2E5A - Shape the Indoor Side Tubing; Arrangement of Tubing by Direction; Wiring Instructions

2-47
Design of VRF SYSTEM
1
2
3
4
5
6
7
8
9
3. How to install the indoor unit
3-6-5. Shape the Indoor Side Tubing
(1)
a) Right or left tubing
Cut out the corner of the right/left frame with a hacksaw
or the like. (Figs. 2-124 and 2-125)
b) Right-rear or left-rear tubing
In this case, the corner of the frame need not be cut.
(2)
Arrangement of tubing by direction
To mount the indoor unit on the rear panel:
Hang the 3 mounting slots of the unit on the upper tabs
of the rear panel. (Fig. 2-126)
3-6-6. Wiring Instructions
General precautions on wiring
(1)
(2)
(3)
(4)
(5)
Before wiring, confirm the rated voltage of the unit as
shown on its nameplate, then carry out the wiring closely
following the wiring diagram.
Provide a power outlet to be used exclusively for each
unit, with a power supply disconnect and circuit breaker for
overcurrent protection provided in the exclusive line.
To prevent possible hazards due to insulation failure, the
unit must be grounded.
Each wiring connection must be done tightly and in
accordance with the wiring system diagram. Wrong wiring
may cause the unit to misoperate or become damaged.
Do not allow wiring to touch the refrigerant tubing,
compressor, or any moving parts of the fan.
Unauthorized changes in the internal wiring can be very
dangerous. The manufacturer will accept no responsibility
for any damage or misoperation that occurs as a result of
such unauthorized changes.
Fig. 2-124
Fig. 2-125
Fig. 2-126
Grille
Grille
Left tubing
outlet
Right tubing
outlet
Fig. 2-128
Fig. 2-127
(6)
3-6-7. Mounting
(1)
(2)
To install the indoor unit, mount the indoor unit onto the 3
tabs on the upper part of the rear plate.
Hold down the air discharge outlet and press the lower part
of the indoor unit until it clicks to securely fasten to the 2
tabs on the lower part of the rear plate. (Fig. 2-127)
NOTE
For tubing, choose either the right or left tubing direction and
follow the steps below. Also, extend the support on the back of
the indoor unit as a stand to make your work easier. (Fig. 2-128)
Push
Rear panel
TDxxxxxx-002WAYVRF.indb47TDxxxxxx-002WAYVRF.indb47 2014/01/3017:52:322014/01/3017:52:32