Panasonic S-36MK2E5A - How to Fix Installation Plate; Wall Mounted (K2 Type)

2-37
Design of VRF SYSTEM
1
2
3
4
5
6
7
8
9
3. How to install the indoor unit
3-5-1. Starting the Installation
(1) Remove the rear panel.
3-5-2. How to Fix Installation Plate
The mounting wall should be strong and solid enough to withstand the unit’s vibration.
(1) Mount the installation plate on the wall with 5 screws or more (at least 5 screws).
(If mounting the unit on the concrete wall, consider using anchor bolts.)
Always mount the installation plate horizontally by aligning the marking-off line with the thread and using a level gauge.
Fig. 2-81
Fig. 2-82
3-5 Wall Mounted (K2 Type)
NOTE
Tubing can be extended in 6 directions as shown in Fig. 2-81.
Select the direction you need providing the shortest run to the
outside unit.
Piping direction
Right
Right Rear
Left
Rear
Left bottom
Left
(Front side)
Right bottom
Model
Dimension
123456
unit : mm
540 82 439 432 43 95
S-22MK**
S-28MK**
S-15MK**
S-36MK**
DISTANCE
TO PIPE
HOLE
CENTER
128 mm
DISTANCE TO
PIPE HOLE
CENTER 128 mm
PIPE HOLE CENTER
PIPE HOLE
CENTER
241.5 mm
241.5 mm
128 mm
128 mm
128 mm
Wall
Wall
Wall
Measuring
Tape
2 screw
More than
1
More than
1
Installation
plate 1
More than 2
The center of installation plate should be at more than 1 at right and left of the wall.
The distance from installation plate edge to ceiling should be more than 2 .
From installation plate center to unit’s left side is 3 .
From installation plate center to unit’s right side is 4 .
For left side piping, piping connection for liquid should be about 5 from this line.
For left side piping, piping connection for gas should be about 6 from this line.
(2) Drill the piping plate hole with ø70 mm hole-core drill.
Putting measuring tape at position as shown in the diagram above.
The hole center is obtained by measuring the distance namely 128 mm for left and right hole respectively.
Another method is intersection point of arrow mark extension.
The meeting point of the extension arrow mark is the hole center position.
Drill the piping hole at either the right or the left and the hole should be slightly slanting to the outdoor side.
(Refer to Section 3-5-3. “To Drill a Hole in the Wall and Install a Piping sleeve”.)
TDxxxxxx-002WAYVRF.indb37TDxxxxxx-002WAYVRF.indb37 2014/01/3017:52:312014/01/3017:52:31