Panasonic S-36MK2E5A - Basic Operations; Start Operation; Operation Mode; Fan Speed

3-6
Control of VRF SYSTEM
1
2
3
4
5
6
7
8
9
1. Operating Instructions
8
(EN)
Basic Operations 1
Start operation. Press
.
(The operation indicator illuminates.)
 To change the setting
(P.10)
 To turn the energy saving
operation ON/OFF
Press during operation. (Only for models equipped with the energy saving function.)
 To stop
(The operation indicator turns off.)
2
Select the item to set. Press Ż Ź.
3
Change the setting. Press Ÿź ĺ .
(The cursor disappears.)
Energy saving operation is in process.
Operation indicator
Note
z Operation modes that cannot be set are not displayed. z The À ap display differs from the actual À ap angle.
z Pressing
after recovery from mains power failure will resume operation with
the contents before mains power failure has occurred.
z If no operation is performed for a certain period of time, the backlight turns off to
save electricity. (Press any button for illumination.)
z The energy saving operation restricts the maximum current value, resulting in
decreased cooling/heating performance. (If the current of outdoor units does not reach the peak due to low load operation, the current value is not restricted.)
z The temperature range that can be set varies depending on the model. z The set temperature range can be changed using the remote controller. (P.2 4) z Some models do not display the À ap.
9
(EN)
Perform the following operations in step 2 on page 8.
 Operation mode (e.g. Cool, Heat, etc.)
Press Ż.
* Auto:
The mode is automatically switched to Cool or Heat to achieve the set temperature.
Ļ
Heat
Dry
Cool
Fan
Auto
 Set temperature
Press . (When the cursor is not
visible)
• Cool/Dry : 18 °C to 30 °C • Heat : 16 °C to 30 °C
• Auto : 17 °C to 27 °C
 Fan speed
Press Ź.
 Flap
Press Ź 2 times.
 Flap Setting for Each Indoor
Unit
(P.12)
• : Swing
• Pressing Ÿź
during swing can stop the À ap at your preferred position.
• 5-level adjustment
is possible during Heat, Fan and Auto (Heat) modes.
Cursor
* Auto:
Cannot be selected in Fan mode.
Ļ
High
Medium
Low
Auto
TD831172-00VRFSYSINDOOR.indb6TD831172-00VRFSYSINDOOR.indb6 2014/06/1316:54:392014/06/1316:54:39