Panasonic S-36MK2E5A - Install the Indoor Unit; Secure the Indoor Unit; Insert the Connection Cable

2-41
Design of VRF SYSTEM
1
2
3
4
5
6
7
8
9
3. How to install the indoor unit
Install the indoor unit
Hook the indoor unit onto the upper portion of installation plate.
(Engage the indoor unit with the upper edge of the installation
plate). Ensure the hooks are properly seated on the installation
plate by moving it in left and right.
Fig. 2-94
Secure the Indoor Unit
Press the lower left and right side of the unit against the
installation plate until hooks engages with their slot
(sound click).
Fig. 2-95
Insert the connection cable
70 – 80 mm
Fig. 2-96
Fig. 2-97
To take out the unit, push the
PUSH
marking at the bottom unit,
and pull it slightly towards you to disengage the hooks from the unit.
(This can be used for left rear piping and bottom piping also.)
Hooks at installation plate
Sleeve for piping hole
Piping
Drain hose
Indoor unit
Installation plate
Unit’s hook
Connection cable
Gas side piping
Liquid side piping
Drain hose
Guide
surface
Connection
cable
About
PUSH marking
TDxxxxxx-002WAYVRF.indb41TDxxxxxx-002WAYVRF.indb41 2014/01/3017:52:322014/01/3017:52:32