Panasonic S-36MK2E5A - Preparation before Installation

2-32
Design of VRF SYSTEM
1
2
3
4
5
6
7
8
9
3. How to install the indoor unit
3-4-2. Preparation Before Installation
(1) Remove the bracket (for suspending the indoor unit).
Loose the M8 suspension bolts.
Then remove the bracket. (Fig. 2-60)
NOTE
Loosen the M8 suspension bolts and expose the axis
of bolts less than 8 mm.
M4 screw for preventing
bracket from taking off
M8 suspension bolts for
suspending the indoor unit
Bracket
Less than 8 mm
Fig. 2-60
(2) Remove the air-intake grille before suspending the indoor unit.
First, remove 2 attachment screws fixed with the latches.
Open the air-intake grille and hold the claws of the hinges on both sides.
Then remove the air-intake grille and suspension lug located on the left and right side of the indoor unit.
When wiring, remove the center bracket if necessary.
When wiring is completed, reinstall the center bracket
in its original position.
1
1
2
Slide
Latch
claws
Screw
Air-intake grille
Fig. 2-61
Air-intake grille
Remove
Remove
Fig. 2-62
(3) Remove the side plate to the tubing side.
(4) Remove the center bracket.
Rear & upper side
tubing connection
Remove 2 screws.
Slide the side plate in the direction of
the arrow and remove it.
Right side tubing
connection
Do not remove the side plate.
Remove
Screw
Side plate
Fig. 2-63
Center bracket
Fig. 2-64
TDxxxxxx-002WAYVRF.indb32TDxxxxxx-002WAYVRF.indb32 2014/01/3017:52:312014/01/3017:52:31