Panasonic WJ-NV200K - Play images from a designated point; Play image recorded at a designated time and date

27
Connection for the auto time adjustment function
When a signal output from the other device is supplied to the time adjustment signal input (pin no. 20) and the time difference
between the recorder and the other device is 29 minutes or less, the clock of the recorder will be set to the time set for the other
device.
When a signal output is supplied to the recorder 29 minutes before/after the hour, the clock of the recorder will be set to the hour
(nn:00:00). ("nn" is the hour.)
Example:
 • Signalissuppliedat2:50:00pm→ Set at 3:00:00 pm
 • Signalinputsuppliedat3:28:45 pm → Set at 3:00:00 pm
 • Signalissuppliedat3:29:30 pm → Time will not be adjusted.
Note:
 • Whenadjustingthetimeusingthetimeadjustmentsignalinput,select"On"for"Autotimeadjustment".(☞ Page 42)
Connection of the control output
When an alarm device such as a buzzer or a lamp is connected, the signal output from pin no. 20 and pin nos. 15 - 19 can be
used to notify the status by sounding a buzzer or lighting a lamp.
The connection example of the HDD error output (pin no. 16) is as follows.
13 20
Signal ground Sensor signal input Alarm input Alarm reset input Series recording output Time adjustment signal input Signal ground Alarm output Alarm reset output Alarm recording During recording Disk Buzzer output System error output Thermal error output Time adjustment signal output Series recording output
Output for the
indicators on
the front panel
Terminal of the other device
ALARM/CONTROL
(Signal ground)
(Time adjustment signal input)
13 16
(Signal ground)
(HDD error output)
ALARM/CONTROL
Alarming device
* Attached when necessary
Relays, etc.*