Panasonic WJ-NV200K - Search and play recorded images triggered by motion detection (VMD search)

32
Turn off the power of the recorder
Turn off the power of the recorder. When turning off the power, follow the procedure "During recording" or the procedure "During
playback" depending on the current operation status.
During recording
Step 1
Select "Off" for "Recording mode" on the "REC & event"
page - [Advanced setup] tab of the setup menu to stop all
recordings. (☞ Page 58)
Step 2
Unplug the power plug from the outlet after confirming that
the [HDD] and [HDD2] indicators are off.
→ The [OPERATE] indicator will go off.
Note:
 • Besuretoperformtheoperationtostartrecording(select "On" for "Recording mode") after turning on the power of the
recorder again.
During playback
Step 1
Stop playback.
(☞ Operating Instructions (PDF))
Step 2
Unplug the power plug from the outlet after confirming that
the [HDD] and [HDD2] indicators are off.
→ The [OPERATE] indicator will go off.
Important:
 • Removetheplugfromtheoutletifnotoperatingtherecorderforalongperiod.
 • Turnonthepower(approximatelyonceaweek),andperformrecording/playbacktopreventinterferenceswithfunctions.