Panasonic WJ-NV200K - Basic operation

15
Power source
The input power source for this product is 120 V AC 60 Hz
(WJ-NV200K), 220 V – 240 V AC 50 Hz/60 Hz
(WJ-NV200K/G). Do not connect to the outlet that provides
the power to equipments that requires a measurable amount
of power (such as a copy machine, air conditioner, etc.).
Avoid placing this product in locations where is subject to
water.
* The provided power cord(s) is (are) dedicated to the use
with this product.
Ambient operating temperature
Use this product at temperatures between +5 °C to +45 °C
{41 °F to 113 °F}. Failure to do so may damage the internal
parts or cause malfunction. Performance and lifetime of hard
disk drives are easily affected by heat (used at high tempera-
ture). It is recommended to use this product at temperatures
between +20 °C to +30 °C {+68 °F to +86 °F}.
To cut the power supply
This product has no power switch. To cut the power supply,
unplug the power plug of the product from the AC outlet. If it
is hard to unplug the power cord due to the installation con-
ditions, connect the power cord of the product to the AC
outlet via the circuit breaker of a distribution board or to the
AC inlet socket of a power supply control unit.
Built-in backup battery
 • Beforethefirstuse,chargethebuilt-inbackupbattery
(lithium battery) by turning on the power for 48 hours or
more. If it is not charged enough, in a case where the
power goes down, the internal clock may keep bad time
or the operative condition may be different to that before
the electric power failure.
 • Thebuilt-inbatterylifeisapprox.5yearsasanindication
of replacement. (The built-in battery life may become
shorter depending on the use condition.) Replace the
built-in battery after 5 years of use. ("5 years of use" is
just an indication of replacement. We are not providing
any guarantee of the built-in battery lifetime.) When the
built-in battery life runs out, some settings such as the
time and date setting will not be saved once the power
is turned off.
 • Askyourdealerwhenreplacementofthebatteryis
required.
Hard disk drive (HDD)
 • Harddiskdrivesarevulnerabletovibration.Handlethem
with care. It is possible to damage them if they are
moved while their motors are still running.
 • Donotmoveorinstallthisproductjustafterturningthe
power on or off (for around 30 seconds.) The hard disk
drives are running.
 • Thelifetimeofharddiskdrivesislimitedbyuse.Write
errors may occur frequently after around 20 000 hours of
operation, and the head and motor deterioration may
occur after around 30 000 hours of operation. They will
reach the end of their lifetime after 30 000 hours of oper-
ation if they have been used at the recommended ambi-
ent temperature (approx. +25 °C {77 °F}).
 • Topreventdatalossfromdiskclashes,itisrecommend-
ed to keep the ambient operating temperature below
+25 °C {77 °F} and to replace them after around 18 000
hours of operation.
 • Whenharddiskdrivetroubleoccurs,replaceitimmedi-
ately. Contact your dealer about servicing.
About SDHC/SD memory card
 • WhenusinganunformattedSDHC/SDmemorycard,
format it using this product. Recorded data on the
SDHC/SD memory card will be deleted when formatted.
If an unformatted SDHC/SD memory card or an SDHC/
SD memory card formatted with other devices is used,
the product may not work properly or performance dete-
rioration may be caused. Refer to the Operating
Instructions (PDF) for how to format a SDHC/SD memo-
ry card.
 • WhensomeSDHC/SDmemorycardsareusedwiththe
product, the product may not work properly or perfor-
mance deterioration may be caused. Use the SDHC/SD
memory cards recommended in page 92.
 • Refertopage19 for how to insert/remove a SDHC/SD
memory card.
Prevent condensation from forming
If this happens, it can cause malfunction.
Leave it switched off for around 2 hours in the following
cases.
 • Whenthisproductisplacedinanextremelyhumid
place.
 • Whenthisproductisplacedinaroomwhereaheater
has just been turned on.
 • Whenthisproductismovedfromanair-conditioned
room to a humid and high-temperature room.
About the monitor
When displaying the same image on the monitor for a long
time, the monitor may be damaged.
When this product is not supposed to be used for a
certain period
Turn on the power (approximately once a week), and per-
form recording/playback to prevent interferences with func-
tions.
Cleaning
Turn the power off, and then use a soft cloth to clean this
product. When the dirt is hard to remove, use a mild deter-
gent and wipe gently. Wipe out the detergent completely
using a soft cloth.
Do not use strong or abrasive detergents when cleaning the
body.
When using a chemical cloth for cleaning, read the caution
provided with the chemical cloth product.
Indication label
Refer to the indication label placed on the surface of this
product for the equipment classification and power source,
etc.
Precautions