Panasonic WJ-NV200K - Replace the Hard Disk Drives

30
Important:
 • Harddiskdrivesareprecisedevices.Handlewithcare
while keeping the following in mind.
 • Donotsubjecttheharddiskdrivetoanyvibrationor
impact.
 • Beforetouchingtheharddiskdrive,eliminatestaticelec-
tricity by touching a steel locker, etc. When holding the
hard disk drive, hold the both sides of the hard disk
drive.
 • Donottouchthecircuitboardortheconnectorstopre-
vent the hard disk drive from damaging by static electric-
ity.
 • Contactyourdealerforharddiskdrivesthatworkson
the recorder. Please be forewarned that operation with
any hard disk drive other than the specified models is
not guaranteed under any circumstances.
 • Whenusingmultipleharddiskdrives,usethesame
model.
If different models are used together, even when the
capacities of them are the same, the available capacity
may be a few percent smaller.
Note:
 • Harddiskdrivesarelocallyprocured.Contactyourdeal-
er for purchasing, installing, and replacing the hard disk
drives.
Replace the hard disk drives
When replacing a hard disk drive with another one, it is necessary to format the hard disk drive or to perform the removal pro-
cess. In this case, do the following.
Step 1
Perform the removal process of the hard disk drive.
(☞ Page 29)
Step 2
Turn off the power of the recorder. (☞ Page 32)
Step 3
Pull out the HDD unit from the rear panel of the recorder by
referring to Step 1 of "Install the hard disk drives" (☞ page
29).
Step 4
Install the hard disk drive into the HDD bracket by referring
to Step 2 of "Install the hard disk drives" (☞ page 29).
Step 5
Insert the HDD unit into the HDD slot by referring to Step 3
of "Install the hard disk drives" (☞ page 29).
Step 6
Turn the power of the recorder, and format the hard disk
drive on the [Format HDD] tab of the "HDD management"
page of the setup menu. (☞ Page 76)
→ Hard disk drives that that are newly installed will auto-
matically be formatted when they are recognized. When
the formatting is completed, the hard disk drives will
become operable.
Step 7
If the installed hard disk drive is formerly used for recording
and currently used for playback use only, perform the link
process (☞ page 75) on the "HDD management" page of the
setup menu.