[Panasonic alarm protocol]
Click “Panasonic alarm protocol notification >>” to display the setup menu that can configure the settings
relating to transmitting Panasonic alarm protocol notifications when an alarm occurs. The setup menu will be
displayed in a newly opened window. (®page 161)
[HTTP alarm notification]
Click “HTTP alarm notification setup >>” to display the setup menu that can configure the settings relating to
transmitting HTTP alarm notifications when an alarm occurs. The setup menu will be displayed in a newly
opened window. (®page 162)
2.7.4.1 Configure the settings relating to Preset per sender (“Preset
per sender” setup menu)
On the [Alarm] tab of the “Alarm” page (®Page 153), click “Preset per sender” for “Command alarm”.
The sender’s address for the command alarm, and the preset position for that address can be registered in
this section.
[Sender’s address 1] - [Sender’s address 8]
Set the sender’s IP address for the command alarm, and the preset position for that address. Up to 8 notification
addresses can be set.
[Auto track cooperation] checkbox: When the checkbox is selected, auto tracking starts after the direction
of the camera moves to the preset position.
[Close] button
Click this button to close the “Preset per sender” setup menu.
2.7.4.2 Configure settings relating to image quality on alarm action
Click “Image compression rate upon alarm detection setup >>” of “Camera action on alarm” on the [Alarm] tab
of the “Alarm” page. (®page 153)
156 Operating Instructions
2 Settings
To Next Page
Loading...
