2.9.2.7 Configure the settings relating to SNMP
The settings relating to SNMP can be configured on this page. It is possible to check the status of the camera
by connecting to the SNMP manager. When using the SNMP function, contact the network administrator.
[SNMP version]
Select the SNMP version to be used.
• SNMPv1/v2: SNMPv1/v2 is activated.
• SNMPv3: SNMPv3 is activated.
• SNMPv1/v2/v3: SNMPv1/v2/v3 is activated.
• Default: SNMPv1/v2
[SNMPv1/v2] - [Community]
Enter the community name to be monitored.
• Available number of characters: 0 - 32 characters
• Default: None (blank)
IMPORTANT
• When using the SNMP function, it is necessary to enter the community name. When no community
name is entered, the SNMP function will not work.
[SNMPv3] - [User name]
Set the SNMPv3 user name.
• Available number of characters: 0 - 32 characters
• Unavailable characters: " & : ; \
[SNMPv3] - [Authentication]
Select the SNMPv3 authentication method from MD5 or SHA1.
• Default: MD5
[SNMPv3] - [Encryption method]
Set the SNMPv3 password.
• Default: DES
Operating Instructions 201
2 Settings
To Next Page
Loading...
