• If access often fails due to the change in the global address of router, set a smaller value for “Access
interval”.
Checking the information registered for the “Viewnetcam.com” service
It is possible to check if the camera has been registered for the “Viewnetcam.com” service. (®page 236)
2.9.6.2 When using “Dynamic DNS Update”
[Host name]
Enter the host name to be used for the Dynamic DNS Update service.
• Available number of characters: 3 - 250 characters
Enter in the form of “(host name). (domain name)”.
• Available characters: Alphanumeric characters, the colon (:), the period (.), the underscore (_), and the
hyphen (-).
• Default: None (blank)
Note
• Refer to the network administrator for further information about the available host names.
[Access interval]
Select the interval to access the Dynamic DNS Update service server to check the IP address and the host
name from the following.
10min/ 20min/ 30min/ 40min/ 50min/ 1h/ 6h/ 24h
• Default: 24h
Operating Instructions 225
2 Settings
To Next Page
Loading...
