Pantech Link II - Alert Message

100
Alert message
Ifyouexperienceanyproblemwhileusingyourmobilephone,pleaserefertothefollowing
checklist. If the problem still persists, contact your dealer or nearest carrier.
When the “Insert SIM Card” message appears:
Make sure the SIM card is correctly installed. Check to see if the SIM card is working properly. If it
does not work, try to clean the contact points of the card with a dry cloth. If it is out of order, take it
to your service provider.
When the “Messages full” message appears:
The received or saved messages are full in your phone memory. You need to delete the message.
When the “Phone and SIM messages are full. Delete Messages” message appears:
The received or saved messages are full in your phone and SIM card memory. You need to delete
the message.
When the “Password” message appears in Phone locked state:
Enterthephonepassword.Thedefaultpasswordis”1234”.Ifyoucannotrememberthepassword,
contact the nearest carrier.
When the “Enter PIN1” message appears:
InputPIN1.Ifyoucannotrememberit,contactyourserviceprovider.Youcanstillreceive
callsevenifyourmobilephonebecomeslockedafterenteringtheincorrectPIN1onthree
consecutive attempts.
When the “No Service” or “Network Search” appears:
If you cannot make/receive a call when you are indoors or undergrounds where the signal
strength is poor, move toward a window or go out to an open area. If you still cannot make a
connection, contact your service provider.