MG5000+ / MG5050+ Installation Guide
41
Example: The system is armed and zone 1 has been breached causing an alarm. If options [5] and [7] are OFF and option [6] is ON in section [802], the control panel
will attempt to communicate with MSTN 2.
Account Numbers
Section [811]: Partition 1, Section [812]: Partition 2
All report codes are preceded by a 4-digit or 3-digit Partition Account Number to ensure correct identification in a partitioned system. Partition account numbers
can be any hexa-digit from 1 to F. To enter a 3-digit account number, simply press the [
SLEEP] key followed by a 3-digit account number. Also, when using 3-digit
account numbers, you must use 1-digit report codes.
Dialing Method
Section [800]: Dialer Options
Option [6] OFF= Pulse Dialing (see “Pulse Ratio” on page 41).
Option [6] ON= Tone/DTMF Dialing (default)
Pulse Ratio
Section [800]: Dialer Options
Option [7] OFF= European Pulse Ratio of 1:2
Option [7] ON= U.S.A. Pulse Ratio of 1:1.5 (default)
When using Pulse dialing, you can select one of two Pulse Ratios. Although most European countries use the 1:2 pulse ratio, the 1:1.5 ratio may provide better results
in some cases. The same applies for North American countries. If the 1:1.5 pulse ratio is not providing the desired results, the 1:2 ratio may be used.
Maximum Dialing Attempts
Section [831]
000 to 255 attempts, Default = 8 attempts
The value programmed in section [081] determines how many times the control panel will re-dial the same monitoring station telephone number before
proceeding to the next number.
Maximum Dialing Attempts - VDMP3
Section [841]
000 to 255 attempts, Default = 8 attempts
The value programmed in section [841] determines how many times the control panel will re-dial the same telephone number before proceeding to the next
number. The maximum dialing attempts programmed in this section is independent from those programmed in section [831] of the panel dialer used for
monitoring station reporting.
Delay Between Dialing Attempts
Section [832]
000 to 255 seconds, Default = 20 seconds
This delay determines the amount of time the control panel will wait between each dialing attempt. This section applies to the Plug-in Voice Dialer when using
a VDMP3.
Switch to Pulse on 5th Attempt
Section [800]
Option [3] OFF= Switch to Pulse on 5th Attempt Disabled (default)
Option [3] ON= Switch to Pulse on 5th Attempt Enabled
With option [3] ON, the control panel will switch to pulse dialing on the 5th attempt of reaching the monitoring station.
Alternate Dial Option
Section [800]: Dialer Options
Option [4] OFF= Alternate Dial Disabled (default)
Option [4] ON= Alternate Dial Enabled
With option [4] OFF, the control panel will dial the backup programmed in section [817] after all attempts to one monitoring station number have failed. With
option [4] ON, the control panel will dial the backup number after every failed attempt.
Force Dial Option
Section [800]: Dialer Options
Option [5] OFF= Force Dial Disabled
Option [5] ON= Force Dial Enabled (default)
With option [5] is enabled, the panel will dial a telephone number even if no dial tone is present after 4 seconds.
To Next Page
Loading...
Need help?
General
