Paradox MG5000+ User Manual

MG5000+ / MG5050+ Installation Guide
45
When armed, the PGM will pulse once every 30 seconds.
Option [6] OFF= PGM Pulse on any alarm disabled (default)
Option [6] ON= PGM Pulse on any alarm enabled
This option sets the PGMs to pulse on any alarm.
Option [7] OFF= PGM Pulse on any alarm Partition 1(default)
Option [7] ON= PGM Pulse on any alarm Partition 2
Program PGMs to pulse during an alarm for either partition. With this feature enabled, and in combination with the Follow Arm/Stay Arm/Sleep Arm PGM type, the
PGM will mimic the Arm LED.
PGM Programming
Sections [301] to [316]
The programming of the PGMs is accomplished in two steps:
1. Assign the PGMs to the panel.
2. Program the PGMs.
PGM Programming can be executed through the Installer Quick Menu in the programming guide.
How Do I Assign PGMs to the Panel?
1. Press the [
ENTER] key.
2. Enter your [
INSTALLER CODE] (default: 0000 / 000000) or [MAINTENANCE CODE] (empty by default)
3. Enter the desired [
SECTION NUMBER] (from sections [301] to [316]).
4. Enter the 6-digit [
SERIAL NUMBER] of the PGM.
How Do I Delete Assigned PGMs?
1. Press the [
ENTER] key.
2. Enter your [
INSTALLER CODE] (default: 0000 / 000000) or [MAINTENANCE CODE] (default 1111/111111)
3. Enter the desired [
SECTION NUMBER] (from sections [301] to [316]).
4. Press the [0] key six times to clear the serial number.

Paradox MG5000+ Specifications

General

StayD Mode	Yes
Zones	32
Wireless Expansion	Yes
Remote Control	Yes
PGMs	2
Remote Controls	Compatible with MG/SP remote controls
Battery Backup	12V 7Ah battery (not included)
Outputs	2 programmable outputs