Paradyne COMSPHERE 3610 - Page 111

Index
Index-73610-A2-GB46-60 December 1996
R
rate
adaption, 1-1
automatic detection, 1-1
Rate(Kbps), configuration option, 4-2
RDL, respond to, 4-12
rear panel, 2-9
Receive
Elastic Store, 4-3
Line Signal Detect (RLSD), for MCMP, 4-14
receive signal loss, DDS circuit quality, 3-7
remote
configuration option sets, 2-7
digital loopback, 3-11
DSU, 3-14
DTE digital loopback, 4-12
menu, 3-5
Remote branch, 3-17
requirements, government, C
Reset
Control branch option, 3-17
initiate power-up routine, 2-5
power on test, 4-15
Transmitter control (TxCtl), 3-17
Resp Period, 4-7
RespondRDL, 4-12
response period, 4-7
RL by DTE, 4-12
RLSD in MCMP, 4-14
RPower, message, E-9
RPowr, ExtLeads, 4-13
RTS, LED status indicator, 3-4
RTS Cntrl, Request-to-Send, 4-10
RXC, TxClkSource, 4-2
RXD, LED status indicator, 3-4
RxElasStor, 4-3
S
S#, serial number ID display, 3-8
S1 switch setting, how to verify, 2-2
save, configuration option changes, 2-7, 3-14
scrambler, 64CC, 4-4
screen types, async terminal, C-5
SDCP
for model 3611, 3-2
Lamp test, 3-13
security
for DBMs, 1-3
for front panel, 3-18
self-test, Device test, 3-10, 3-14
SEQU, App Modul ID display, 3-8
signal ground, switch, 2-2
signal loss, circuit quality display, 3-7
SNA Backup, 4-16
SNA diagnostic interface. See LPDA-2
software version control, 4-13, G-2
specifications. See technical specifications
SPID, Configuration branch, 3-16
standby mode, 3-4
network interface, 3-9
status
indicators, 3-4–3-6
for async terminal, C-5
Lamp test, 3-13
system, 4-11
Status (Stat) branch, 3-6–3-8
circuit quality (CircQ), 3-7
DTE status, 3-7
Identity (ID), 3-7
terminal power, 3-7
Stndby, message, E-9
stop bits, 4-15
for async terminal, 3-5, C-1
Stream, message, E-9
streaming. See AntiStreaming
subnetwork (subn), health and status, 3-7
SubSpd, message, E-9
SW Vers, 4-13
firmware version, 3-8–3-9
switched-carrier emulation, 1-4
SystemStat, 4-11
T
TDM
See also 3610-A2-GB48
capabilities, 1-4
technical specifications, F-1–F-6
3600 hubbing device, F-6
async terminal, F-6
DSU, F-5
general 3600 Series, F-2–F-4
Term: Stndby message, E-2
terminal power, 3-7
test
data set ready (DSR), 4-11
LED, 3-4
message, E-9
mode
EIA-232 or V.35, 2-2–2-3
LED, 3-4
network verification, 2-8
pattern for BERT test, 3-13
power-on, 4-15
Test branch, 3-9
abort, 3-9
selective, 3-9
subnetwork (Subn), 3-9
Bit Error Rate Test (BERT), 3-13
Device (Devic), 3-10
Dial tone test, 3-13
Digital test (DT), 3-12
End-to-End test (EE), 3-12
Lamp test, 3-13
Loopback, 3-10–3-11
messages, E-6, E-7
Thresh, message, E-9
TIA. See EIA-232
time-out, tributary, 4-7