COMSPHERE 3600 Series Data Service Units
C-6 December 1996 3610-A2-GB46-60
To
access the Configure branch:
PRESS: 4 – Confg
The Configure Menu Selection screen appears and is
comparable to selecting
Confg from the front panel.
Customer ID:
ORLANDO2
Model:
COMSPHERE 3610
Configure:
1 – Opts T/Ctrl–T=T
op Menu
2 – PList U/Ctrl–U=
Up Menu
3 – Dir
V/Ctrl–
V= V
iew H/S
4 – Phone
5 –
Addr
6 – ChgMd
7 –
Term
PRESS Desired Selection Key:
Ctrl–x = Disconnect
Changing External Leads
The External Leads configuration option must be set
before external leads can be displayed or changed. T
o set
external leads, select ExtLd from General Configuration
Options (Table 4-4). After External Leads is enabled:
. Procedure
1. From the Second-Level Menu screen:
PRESS: 5 – Ctrl
2.
The Control Function Menu selection screen
appears.
PRESS: 3 – ExtL
3.
The External Leads Menu selection screen
appears.
PRESS:
2 – Chang
Customer ID:
ORLANDO2
Model:
COMSPHERE 3610
External Leads:
1 – Displ T/Ctrl–T=T
op Menu
2 – Chang U/Ctrl–U=
Up Menu
V/Ctrl–V=View H/S
PRESS Desired Selection Key:
Ctrl–x = Disconnect
4. The External Leads Input screen appears. The
OutA or OutB field will be highlighted. To
change the value of the bolded field:
PRESS: 1 – Toggle
The highlighted field will change from high to
low or vice versa for on and off. At the front
panel, use the
↑↓
keys instead. T
o move between
the OutA and OutB fields, use the <
Tab
> key on
the keyboard. At the front panel, use the or
key
.
Customer ID:
ORLANDO2
Model:
COMSPHERE 3610
OutA
:^ OutB:_
1 – Toggle T/Ctrl–T=T
op Menu
2 – Save U/Ctrl–U=
Up Menu
V/Ctrl–V=V
iew H/S
PRESS Desired Selection Key; <T
AB> to go between fields
Ctrl–x = Disconnect
5. If the value of either field is changed:
PRESS: 2 – Save
To Next Page
Loading...
