Async Terminal Operation
C-73610-A2-GB46-60 December 1996
Input Screens
Input screens require data input followed by the
carriage return <CR
> key
. The options to enter T for top
menu, U for up one menu, and H for Health and Status
do not appear. They are disabled for input screens;
Ctrl-T, Ctrl-U
and
Ctrl-V
continue to be available
along with Ctrl-x.
Customer ID (CID)
The Customer ID field appears on the second line of
every screen.
. Procedure
1. From the Configure Menu Selection screen, to
enter or change the Customer ID:
PRESS: 6 – Term
2. The Async T
erminal Menu screen appears with
Term: Enab as the third line. T
o access the
Customer ID:
PRESS: 4 – CID
Customer ID:
ORLANDO2
Model:
COMSPHERE 3610
T
erm: Enab
1 – Enab T/Ctrl–T=T
op Menu
2 – Disab U/Ctrl–U=
Up Menu
3 – Pswrd V/Ctrl–V=View H/S
4 – CID
PRESS Desired Selection Key:
Ctrl–x = Disconnect
3. From
the Customer ID Menu screen, to set up or
change the Customer ID:
PRESS:
1 – Chang
The Customer ID input screen appears. The
Customer ID can be up to 8 characters.
Valid Customer ID Entries
Input
ID Entry
Alpha a
to
z Upper or lowercase
accepted. Display always
uppercase.
Numeric 0
to
9
Characters #
–
.
/
Pound sign
Dash
Period
Backslash
If you enter an invalid character, the entry is
ignored. If the terminal is set up for sound, the
terminal beeps when there is an invalid entry.
4. After entering the Customer ID (CID), press the
carriage return <CR>. The Customer ID menu
screen reappears.
PRESS: 2 – Save
When the confirmation message
Command
Complete appears after saving the CID to memory, the
CID will appear on every screen and you can access
other menus.
Amount of Time Input Fields
Three input screens have an amount-of-time prompt
for specific user input. The input field must be fully
populated. The three screens are:
• Digital T
est Run T
ime
• Configuration Diagnostic Tributary Time Out
(TribTimOut)
• Configuration Backup Network Time Out
(NtwkTimOut)
To Next Page
Loading...
