Cont. ix
Restoring Saved Settings 6-25
Copying an Application 6-25
CHAPTER 7 TRIPS AND FAULT FINDING
Trips and Fault Finding ........................................................................7-1
Trips 7-1
• What Happens when a Trip Occurs 7-1
Fault Finding .......................................................................................7-2
• Initial Troubleshooting Procedure 7-2
• Calibration Checks 7-4
• Alarm Messages 7-8
• Hexadecimal Representation of Trips 7-9
• Power Board LED Trip Information (Frame 4, 5, 6 & 7) 7-10
Using the Keypad to Manage Trips 7-14
Hardware Troubleshooting 7-23
• Control Power Missing 7-23
• Field Fail Procedure 7-25
• Contactor Failed Procedure 7-26
• SCR Troubleshooting 7-27
• Motor Checks 7-28
Common Performance Problems 7-29
Test Points 7-30
CHAPTER 8 ROUTINE MAINTENANCE AND REPAIR
Maintenance .......................................................................................8-1
• Service Procedures 8-1
• Preventive Maintenance 8-1
Repair ................................................................................................8-2
Saving Your Application Data 8-2
Returning the Unit to Parker SSD Drives 8-2
Disposal 8-3
Technical Support Checks 8-3
Repairs for Frames 4 & 5 8-5
• Replacing the Fan (Frames 4 & 5) 8-5
Repairs for Frame 6 8-6
• AC Fuse Replacement (Frame 6 Non-Regen Unit - 2Q) 8-6
• DC Fuse Replacement (Frame 6 Regen Unit - 4Q) 8-7
•
Replacing a Phase Assembly (Frame 6) 8-9
•
Replacing a Fan (Frame 6) 8-10
Repairs for Frame 7 8-11
• Fuse Replacement (Frame 7) 8-11
• Phase Assembly Replacement (Frame 7) 8-14
APPENDIX A SERIAL COMMUNICATIONS
System Port (P3)...................................................................................A-1
UDP Support A-2
• System Port (P3) Set-up A-2
• UDP Transfer Procedure A-2
• MMI Dump Procedure A-4
DSELite Support A-5
• System Port (P3) Set-up A-5
5703 Support A-6
• System Port (P3) Set-up A-8
EI Bisynch ASCII Support A-9
• System Port (P3) Set-up A-9
EI Binary Support A-14
• System Port (P3) Set-up A-14
• EI Bisynch Binary Message Protocol A-16
• EI Bisynch Binary Parameter Specification Tables A-20
Error Codes A-29
• ERROR REPORT (EE) A-29
APPENDIX B CERTIFICATION
Introduction ........................................................................................B-1
Europe ...............................................................................................B-1
What are the European Directives? B-1
CE Marking for the Low Voltage Directive (LVD) 2006/95/EC B-2
CE Marking for the EMC Directive 2004/108/EC B-2
United States of America & Canada ........................................................B-4
Compliance B-4
Conditions for Compliance with UL508c B-4
• Solid-State Motor Overload Protection B-4
• Branch Circuit/Short Circuit Protection Requirements B-5
• Short Circuit Rating B-6
•
Field Wiring Temperature Rating B-6
•
Operating Ambient Temperature B-6
To Next Page
Loading...
